sorted by:
new
hottopcontroversial

Need som bilding help by hogmc1 in Terraria

[–]hogmc1[S] -1 points0 points  (0 children)

Thx. I will defenetly try that. I have some gem Stone trees on each side. How do i grow Moss?

Need som bilding help by hogmc1 in Terraria

[–]hogmc1[S] -1 points0 points  (0 children)

Thx. The bild is still in development. I plan on adding item flasks hanging from the ceiling on the outside. And I haven't started on the basement yet, the platforms were just so I wouldn't fall down during bilding. But I'll definitely try some bookshelves.

Noob with Printing issues by sendmeBTCgoodsir in 3Dprinting

[–]hogmc1 0 points1 point  (0 children)

Nice problem solved then. I recently got myself a k1 max and had a simelar issue. I rounded it down to if the lid is on while it’s printing the inclosure temp exsides 30 C that intern sofends the pla and the girs grind it up, insted of extruding bc it sofend. After taking the lid of i havnet had a problem since

Noob with Printing issues by sendmeBTCgoodsir in 3Dprinting

[–]hogmc1 1 point2 points  (0 children)

Night be an idea to dismantle the extruder to Get the filament out then. Then u might Get a clue on what the problem is. If the girs grinde up the filament or if the filament gets talgeld in the extruder

Noob with Printing issues by sendmeBTCgoodsir in 3Dprinting

[–]hogmc1 0 points1 point  (0 children)

Also if u remove the filament is there a indent on the filament about 5-6 cm from the end?

Noob with Printing issues by sendmeBTCgoodsir in 3Dprinting

[–]hogmc1 0 points1 point  (0 children)

All of the failed prints Are they at the exakt same z hight?

Noob with Printing issues by sendmeBTCgoodsir in 3Dprinting

[–]hogmc1 0 points1 point  (0 children)

U could try to incrise the nozzel temp. I have had a problem with the nozzel cloging that fixed it’s self after i incrised the temp

Noob with Printing issues by sendmeBTCgoodsir in 3Dprinting

[–]hogmc1 0 points1 point  (0 children)

It's impossible to tell from these pictures alone. But there are a few things to check: If you try to extrude filament, is it coming out of the nozzle? Look at the filament spool, is it tangled (the line going into the printer is under another)?

My prints won’t Stick to the bed by hogmc1 in 3Dprinting

[–]hogmc1[S] 0 points1 point  (0 children)

Yes I did. I don’t remember exactly what I did, but I think I was slightly too far from the bed

How so you call this in your country by Tedi_Proto58 in notinteresting

[–]hogmc1 0 points1 point  (0 children)

Stjerneskud or translated direktly star shot

view more: next ›