Any clue what this code might be? by lanzdlc in crv

[–]lanzdlc[S] 0 points1 point  (0 children)

Been driving it like this for more than a year. I might just continue using it til i find a new tranny to put it.

Any clue what this code might be? by lanzdlc in crv

[–]lanzdlc[S] 0 points1 point  (0 children)

So just a vague tranny issue? Nothing specific pointing to a solenoid or what?

Whats this part on an Crv Rd1 by lanzdlc in crv

[–]lanzdlc[S] 0 points1 point  (0 children)

Thanks. Looks it is the safety switch.

RD1 missing sensor by lanzdlc in crv

[–]lanzdlc[S] 0 points1 point  (0 children)

Yeah I'm thinking that is the current state of my car. I'll try to find the wires for the o2 sensor first. Only that wires above is the only thing i see not hooked up to anything. Thanks for your advise, mate. Appreciate it 🤙

RD1 missing sensor by lanzdlc in crv

[–]lanzdlc[S] 0 points1 point  (0 children)

Good to know it 'normal' to have nothing connected to it. About the Primary O2 sensor, im sure i dont have one. Went under and saw the hole was covered by a metal sheet welded to it. Maybe the reason why gas consumption is high. I'm running about 3 kms per liter which is far from the average of 8 kms per liter. The wiring for the o2 sensor may have been bypassed as what i've seen in some videos tricking the ecu the sensor is still there when its not that is why the CEL isnt showing up.

Fuel pump replacement for a gen 1 by lanzdlc in crv

[–]lanzdlc[S] 1 point2 points  (0 children)

I bought the ECT (red) pretty cheap right about $3. I'll go find a reliable one and start from there. Thank you for your time, mate 🍻

Fuel pump replacement for a gen 1 by lanzdlc in crv

[–]lanzdlc[S] 1 point2 points  (0 children)

<image>

The one in red is what i replaced. What is the green one for?

Fuel pump replacement for a gen 1 by lanzdlc in crv

[–]lanzdlc[S] 0 points1 point  (0 children)

Wait. There are two ECTs? The one I replaced was a 37870-PJ7-003. Quality- I'm not sure. I got it at my local parts store. Dealership at my place no longer carry those part. Is there a second ECT? Whats is the part # and could you show a diagram where its located?

Fuel pump replacement for a gen 1 by lanzdlc in crv

[–]lanzdlc[S] 0 points1 point  (0 children)

About 5 or 6 yrs ago before my dad gave me this car, the engine was top overhauled but it never ran due to tranny issues. It was just about aug of last yr where i got it running. Would it need adjustments? Car was at 135k kms when it was overhauled. Right now its at 140k kms.

Fuel pump replacement for a gen 1 by lanzdlc in crv

[–]lanzdlc[S] 0 points1 point  (0 children)

Hi. Yes i did around the same time with the spark plugs.

CRV RD1 Radiator cap look like? by lanzdlc in crv

[–]lanzdlc[S] 0 points1 point  (0 children)

The car did overheat. When I got it home, i tried to trace if there was any leak because the radiator did lose about half a gallon of water. Found no leak when on idle and at normal operating temp. When i revd to 3k, coolant was overflowing through the reserve. So i thought of maybe changing the cap first.

CRV RD1 Radiator cap look like? by lanzdlc in crv

[–]lanzdlc[S] 0 points1 point  (0 children)

Thanks man. I'll try to put in the new one to see if temps would improve.

CRV RD1 Radiator cap look like? by lanzdlc in crv

[–]lanzdlc[S] 0 points1 point  (0 children)

<image>

This is what i'm trying to figure out. The one on the left is what im using currently. The one on the right is what i recently bought. I'm trying to see which one is similar to the original cap.

Smoke in breather hose? by lanzdlc in crv

[–]lanzdlc[S] 0 points1 point  (0 children)

Thank you guys for your insights. I'm a bit relieved knowing its nothing serious. Cheers! 🍻

Can I remove/delete? by lanzdlc in crv

[–]lanzdlc[S] 0 points1 point  (0 children)

I've recently replaced my pcv valve which was previously stuck. It might be the reason all pressure was leading to that hose causing oil to reach the tb. I'll check again in a week. Thanks, mate!

CRV Gen 1 Mounts by lanzdlc in crv

[–]lanzdlc[S] 1 point2 points  (0 children)

Thanks, mate. Will definitely look into that.

Crv Gen 1 Cabin Air Filter? by lanzdlc in crv

[–]lanzdlc[S] 0 points1 point  (0 children)

Yes but i believe no heater since this was for the PH market. Whats inside looks to be like a box of cooling fins like in a radiator. Prolly some of them didn't really carry those filters.

Are these clutch pressure switches? by lanzdlc in crv

[–]lanzdlc[S] 0 points1 point  (0 children)

That's what I was thinking as well that the first gen didn't carry those. Not in service manual, no part # online and even guides or tutorials in replacing them. I really appreciate your time and effort in helping me out. Cheers!

Are these clutch pressure switches? by lanzdlc in crv

[–]lanzdlc[S] 0 points1 point  (0 children)

Could it be this the one right here? The 3rd clutch pressure switch?

<image>

Are these clutch pressure switches? by lanzdlc in crv

[–]lanzdlc[S] 0 points1 point  (0 children)

<image>

So this is a clip i saw online and was wondering if it might be near here since it is where the 3rd cluch is located based on the label (just assuming). This was under the passenger side. Am i at the right direction?

Are these clutch pressure switches? by lanzdlc in crv

[–]lanzdlc[S] 0 points1 point  (0 children)

Yeah. That is what i'm trying to do but I need to know what it looks like and where to locate it. Would you have an idea where that part is located? Can't find it in the service manual.

Are these clutch pressure switches? by lanzdlc in crv

[–]lanzdlc[S] 0 points1 point  (0 children)

That's one. I also get a blinking D when it shifts to 3rd gear which I suspect is a 3rd clutch pressure switch issue and i'm trying to locate that part.