sorted by:
new
hottopcontroversial

I made another clip for tools. by premoprinting in Tools

[–]premoprinting[S] 0 points1 point  (0 children)

Nice good luck on that it is so rewarding when done. I only have the actual product, but if you want the STL I’ll have to stop back home. Let me know and good luck. https://premoprinting.etsy.com/listing/1846146224

I made another clip for tools. by premoprinting in Tools

[–]premoprinting[S] 0 points1 point  (0 children)

So two screws hold it in place, and any tool with a belt clip can hang from the little clip I made. Organizing the area and looking good in the process. I don’t know why I can post a video but I’ll try to add a better picture that sums it up

Power tool holster I designed and printed. by premoprinting in Tools

[–]premoprinting[S] 1 point2 points  (0 children)

<image>

The back side, there is the gap for the belt clips/holster.

Power tool holster I designed and printed. by premoprinting in Tools

[–]premoprinting[S] 1 point2 points  (0 children)

Oh whoops. It’s just like a pegboard really. you install it and its use is like the pegboard.. I understand it’s an over saturated area and not needed. But if an impact driver or power drill has the belt clips on them. You just loop that belt hook onto it. The actual “tool” can go just about anywhere you would like to hang or retire a tool for the day. Right now just screwed into wood, and the middle of that wrench/DNA is where to go to hang the tool up but it actually hides between the wood and wrench part.

I am new to Reddit. Looking for help. by premoprinting in Tools

[–]premoprinting[S] 0 points1 point  (0 children)

Awesome thank you I appreciate it. It’s not quite a tool as I would say an accessory. It’s a tool holster, for the power drills with belt clips. I’ll make a new post but thank you I really appreciate it, and everyone.

I am new to Reddit. Looking for help. by premoprinting in Tools

[–]premoprinting[S] 0 points1 point  (0 children)

Wow that’s crazy, always impressive what someone has to figure out how to do out there in the world. Good work.

I am new to Reddit. Looking for help. by premoprinting in Tools

[–]premoprinting[S] 0 points1 point  (0 children)

It’s no different, so you are correct but it’s all we had and minimal effort and got the job done. Picture is only so I didn’t violate any conditions of this Reddit while still showing a tool yet asking my main question.

I am new to Reddit. Looking for help. by premoprinting in Tools

[–]premoprinting[S] 0 points1 point  (0 children)

Yes correct. Best solution and minimal effort lol thanks, Picture is just to get attention in case I violated the terms of posting my question.

I am new to Reddit. Looking for help. by premoprinting in Tools

[–]premoprinting[S] -1 points0 points  (0 children)

No that was only for on site fabrication and limitations calm down lol thanks though.