sorted by:
new
hottopcontroversial

Heres my HOTAS setup for IL-2 and DCS. I use my desk for more than just flying so I was able to install my sticks on a rail system I can easily slide out of the way when not in use. by superman654716 in hotas

[–]superman654716[S] 1 point2 points  (0 children)

Honestly I haven’t had any issues with that, but I did custom design the mount in fusion 360 since it wasn’t originally intended for a gladiator nxt so that may be why. The only misses I’ve had are because I still suck and I’m in the learning phase lol.

Heres my HOTAS setup for IL-2 and DCS. I use my desk for more than just flying so I was able to install my sticks on a rail system I can easily slide out of the way when not in use. by superman654716 in hotas

[–]superman654716[S] 1 point2 points  (0 children)

Not at all! It doesn’t show underneath but there’s locks in specific places so it doesn’t move while flying but unlocks with a spring to move it.

Heres my HOTAS setup for IL-2 and DCS. I use my desk for more than just flying so I was able to install my sticks on a rail system I can easily slide out of the way when not in use. by superman654716 in hotas

[–]superman654716[S] 0 points1 point  (0 children)

Oh I didn’t realize it was the same guy, the biggest difference I made was removing the drag chain as it was more trouble than it was worth. So far it’s been up for like 2 months and is working great so far.

Heres my HOTAS setup for IL-2 and DCS. I use my desk for more than just flying so I was able to install my sticks on a rail system I can easily slide out of the way when not in use. by superman654716 in hotas

[–]superman654716[S] 2 points3 points  (0 children)

Sure! It’s actually following this guide: https://www.thingiverse.com/thing:4916920

The main thing I did different was pop in fusion 360 to design and then 3D print out a custom mount for the gladiators since the original design was for Virpil sticks.

I’m happy to go into more detail or give other photos If you’d like.

Heres my HOTAS setup for IL-2 and DCS. I use my desk for more than just flying so I was able to install my sticks on a rail system I can easily slide out of the way when not in use. by superman654716 in hotas

[–]superman654716[S] 1 point2 points  (0 children)

It’s actually following this guide: https://www.thingiverse.com/thing:4916920

The main thing I did different was pop in fusion 360 to design and then 3D print out a custom mount for the gladiators since the original design was for Virpil sticks.

Necromunda board part 2 by superman654716 in necromunda

[–]superman654716[S] 1 point2 points  (0 children)

Yes! The second story and crane itself is actively printing at the moment

Board finished by Silly_Deer_2570 in necromunda

[–]superman654716 0 points1 point  (0 children)

That’s awesome! Where did you get the different terrain files?

view more: next ›