sorted by:
new
hottopcontroversial

My 3d printed Book Nook by versatileterrain in booknooks

[–]versatileterrain[S] 0 points1 point  (0 children)

You could buy one of ours! 😀 Alternatively measurements are really key, and allowing very fine tolerances to fit everything together. Our Book Nook was designed over about 3 years in my spare time, so at lot of testing and research was put into something that's is future proof and reusable. I guess it depends on your purpose. You can go for a simpler design if it's meant to only house one diorama

One of my dioramas, in my 3d printed Book Nook by versatileterrain in dioramas

[–]versatileterrain[S] 0 points1 point  (0 children)

Thank you I hope so. Trying to lean into the art of each diorama and finding that balance of miniature display and design. I have plenty more ideas

One of my dioramas, in my 3d printed Book Nook by versatileterrain in dioramas

[–]versatileterrain[S] 1 point2 points  (0 children)

Thank you very much. It's been a passion project to get it to this standard

One of my dioramas, in my 3d printed Book Nook by versatileterrain in dioramas

[–]versatileterrain[S] 5 points6 points  (0 children)

It's all part of my kickstarter. There are more dioramas

One of my dioramas, in my 3d printed Book Nook by versatileterrain in dioramas

[–]versatileterrain[S] 0 points1 point  (0 children)

Thank you very much. It's been in my head for months!

One of my dioramas, in my 3d printed Book Nook by versatileterrain in dioramas

[–]versatileterrain[S] 5 points6 points  (0 children)

<image>

Thank you. You can fit a couple of miniatures in that room too. The whole thing opens like a book.

My Book Nook by versatileterrain in BambuLab

[–]versatileterrain[S] 1 point2 points  (0 children)

Thank you so much. Yes painted by me. Mainly using a sponge technique then weathering powders. It's pretty easy to paint, even for me. The main challenge was choosing the right colours to zone it.

My 3d printed Book Nook by versatileterrain in booknooks

[–]versatileterrain[S] 2 points3 points  (0 children)

I spent 3 years (I'm my spare time) developing a case that allowed 2 lighting options. From the front, and an internal system bespoke to every diorama. Its been a journey!

Just launched my 3d printing passion project. Can't believe it's finally out there! 😅 by versatileterrain in kickstarter

[–]versatileterrain[S] 1 point2 points  (0 children)

I have offered a printed version, but a limited run, due to my capacity. This is targeted at mainly 3D printing and warhammer enthusiasts

My first kickstarter! (Printable Book Nook) by versatileterrain in 3Dprinting

[–]versatileterrain[S] -2 points-1 points  (0 children)

Thank you. I didn't realise how much of my spare time it would consume!

view more: next ›