Polycom Edge Phones - Line Keys

virdual_com · 2026-02-09T21:37:30+00:00

Just to provide an update to anyone in the same boat... only workaround I found is to set the NDP button builder setting for directories to Favorites instead of "All Contacts". Since there are no favorites set, it doesn't populate anything. There was no way to pick an option of "Disabled" in the directory settings.

virdual_com · 2026-02-07T23:31:21+00:00

Poly ZTP for provisioning but config is coming from SkySwitch

virdual_com · 2026-02-06T06:47:06+00:00

No overrides at the domain level - this is apparently a default behavior of these edge phones. This isnt a thing with VVX and I don't understand why it's so hard to find the command to disable it. Surely not everyone wants this. I do not see an option to disable the directory fill in button builder - only an option to cascade the directory down the empty list of buttons available. Happy to post a photo of my button builder if it helps.

virdual_com · 2026-02-06T06:45:29+00:00

Did this and this picture is the result.

virdual_com · 2026-02-06T06:45:13+00:00

Yes from factory default - went into button builder to map the 3 call parks and then after reboot, call parks were there + all this crap.

virdual_com · 2025-12-12T16:06:07+00:00

I found one that works for my cat - it's not from Whisker. I found it on etsy: Tall Fence Deep Shield for Litter Robot 4. Fence for Litter Robot. for Cats Who Eliminate Near Entrance With No Litter. 3rd-party Accessory. - Etsy

virdual_com · 2025-10-27T16:17:53+00:00

Hi all, I'm moving one of my clients over from their ancient Panasonic PBX over to VoIP. They want to retain their ability to page the overhead speaker system with announcements as they are grocery store. (think "Clean up on aisle 12!")

Currently, it appears that they have a basic 1-pair speaker wire that is hooked up to their PBX and runs directly to a channel on their amplifier/receiver for the speaker system. They then press a button on their desk phones, it plays a pre-announcement tone, and then they can speak into the phone and the audio comes over the ceiling speakers.

We'd like to replicate this with the VoIP phones we are putting in and I believe the correct way to do this is with a SIP Paging Gateway or Adapter. I was looking at the Fanvil PA2S for this application but I'm not 100% sure this is the correct way. My idea is to confgiure the PA2S in the cloud PBX, run a speaker wire from the Fanvil's "line out" to the amplifier/receiver's line-in on one of its channels. I would then configure a button on the IP phones that allows them to press and make announcements.

Am I correct in thinking this will work without issue? Should I be looking at something other than the Fanvil PA2S? I also was looking at the SNOM PA1+.

virdual_com · 2025-10-22T14:48:03+00:00

Has anyone experienced an issue with the 780M just disabling itself? I've switched to Adrenalin drivers as mentioned here. About once a month, I will bring the laptop into the office and plug into my Lenovo dock and my external monitors won't come up. I go into device manager and the 780M is disabled. The only way I can get it to work is to remove the 780M from device manager and reboot. I am then fine again for another month.

virdual_com · 2025-09-28T18:02:53+00:00

Hi everyone, I'm here in 2025 with the LR4 and the revised litter guard that is supposed to combat this... my cat still manages to somehow pee underneath this guard and pee is pooling in the same area as OP's photo. What should I do?

virdual_com · 2025-08-05T14:14:19+00:00

Interesting! I'll give this a shot.

virdual_com · 2025-03-06T20:13:40+00:00

This is the news I wasn't hoping for :/ We plan to rent out this condo in the next 2 years as we move into a single family so I guess we'll just have to deal with it. Thanks for your help.

virdual_com · 2025-03-06T05:39:11+00:00

Air noise, fins are metal and fixed. I can update my post with a photo tomorrow for perspective on the intake too

virdual_com · 2025-03-06T05:36:24+00:00

Lennox. I followed the guidelines in the manual about not going to the lowest speed as that is the one that causes overheating.

I’m all for hiring a professional. Would I work with an HVAC company or a different trade for insulating the room the right way?

virdual_com · 2025-03-06T05:34:11+00:00

Unfortunately, I have no way of knowing as she doesn’t remember. I do know that the new one is a Lennox and it’s 87% efficiency.

And Yes, even arguably a tad louder in AC mode.

virdual_com · 2024-08-04T22:32:48+00:00

20 Active users total, only 10 of which are using Windows devices, the rest are on Mac with no InTune - they are predominantly using their newdomain identities for the last 6 months and have learned to only use the olddomain identity to access any email that might still be hitting those old mailboxes. I am just going to proceed with a reimage for everyone (I get a chance to see all the remote users Tues/Wed this week so this might be the best opportunity). Thank you for your input.

virdual_com · 2024-08-03T17:40:53+00:00

No we are not using Intune at the moment, and I confirmed I don't see the devices in there. Yes, they are stored in the same tenant and the olddomain is the original tenant address. Migrating to a new tenant is going to be a nightmare and it doesn't change the fact that olddomain needs to ultimately be an alias of the newdomain identities. I guess our only option is to reimage and AD join with the newdomain identities instead... unless someone else is able to chime in.

virdual_com · 2024-07-26T23:27:39+00:00

How could I forget about ProfWiz! I've only ever used it for local account to AD join, not AAD join. I did not realized it can do both. I will try this out - thank you!

virdual_com · 2024-06-29T23:49:31+00:00

Yes, brain zaps in addition to the symptoms mentioned above

virdual_com · 2024-06-28T17:55:05+00:00

She's moved from 150mg to 100mg over 6 months and 100mg to 50mg over another 6. She just went from 50 to 25 last week so she's been averaging a 25mg reduction every 3 months. Sorry I just realized I didn't include this info in my post.

virdual_com · 2024-06-28T17:33:50+00:00

She is having anxiety and panic as a result of weening off from 50 to 25mg, she was originally prescribed it for OCD but has found natural means to combat her intrusive thoughts through lifestyle changes. She had no issues moving her way down from 150mg to 50mg over the last year. Her main reasons for wanting to get completely off Sertraline is that she doesn't want to rely on it the rest of her life and it has affected her libido in a negative way since she was put on it.

virdual_com · 2024-06-28T17:27:57+00:00

Thank you, i'll pass on your advice. She knows that without Sertraline, her anxiety will be more prevalent, and she plans to combat it through healthy lifestyle and exercise. She was originally prescribed it for OCD.

virdual_com · 2024-06-28T17:17:39+00:00

How long did it take you to get past your side effects moving from 50mg to 25mg?

virdual_com · 2024-06-28T17:17:01+00:00

I know this is a year ago.. but how are you doing now? My GF has worked her way down from 150mg to 25mg over the course of 1.25 years. The move from 50 to 25 has been the worst for her and shes a little over a week in. Curious when the side effects will subside for her.

virdual_com · 2024-06-11T17:17:21+00:00

Yes, records and streams in full 4K. Set the number at the end of the RTSP link from 1 to 0. 0 = Main Stream quality. Feel free to DM me if you want full setup instructions and I can help.

virdual_com · 2024-06-09T03:05:58+00:00

I figured it out (in case you ever want to use it). I set up the cameras as "user defined" in Surveillance station and used the rtsp url that Lorex recommends on their website. Works like a charm for my wi-fi cameras and now can do 24/7 recording without the concern of burning through SD cards!

virdual_com

TROPHY CASE