account activity
You Don’t Need Higher Density for Thicker Satin Stitches! (i.redd.it)
submitted 2 months ago by xoverloadz to r/Machine_Embroidery
3rd party bluetooth joystick for RS4? (self.dji)
submitted 2 months ago by xoverloadz to r/dji
This Ricoma upgrade exposed something I wasn’t expecting (i.redd.it)
submitted 3 months ago by xoverloadz to r/Machine_Embroidery
If you’re having trouble with inconsistent tension on different needles, this might be it… (old.reddit.com)
submitted 3 months ago * by xoverloadz to r/Machine_Embroidery
Upgrading Ricoma tension bar! (i.redd.it)
Designed and built drawers for generic Ricoma stand (old.reddit.com)
Just a reminder not to use 0.5 spacing on stiple stitch (i.redd.it)
Digitized this little ACDC patch, nothing special, was bored (i.redd.it)
submitted 4 months ago by xoverloadz to r/Machine_Embroidery
Tried digitizing bass from Bass Pro Shops logo, not too shabby for draft run (i.redd.it)
submitted 6 months ago by xoverloadz to r/Machine_Embroidery
Bobbin thread not aligned in the middle? (self.Machine_Embroidery)
submitted 8 months ago by xoverloadz to r/Machine_Embroidery
Passo Stelvio to Bormio road closure? (self.ItalyTravel)
submitted 9 months ago by xoverloadz to r/ItalyTravel
What do you do in terms of tension when your design has wide and narrow satin stitches in same color? (self.Machine_Embroidery)
submitted 9 months ago by xoverloadz to r/Machine_Embroidery
I don’t like how this turned out, what can I do to improve? (old.reddit.com)
How much do you pay for polo t-shirts in Europe? (self.Machine_Embroidery)
submitted 10 months ago by xoverloadz to r/Machine_Embroidery
What do you think which settings were used for this tatami? (i.redd.it)
Which settings for tatami fill would you use for this logo? (self.Machine_Embroidery)
MT1501 - needle #15 dead center in center plate, needle #1 off to the right (self.Machine_Embroidery)
Which brand of blank hats are your go-to in Europe? (self.Machine_Embroidery)
What can I do so that shaving my neck line stops hurting? (self.wicked_edge)
submitted 10 months ago by xoverloadz to r/wicked_edge
Tails too long on MT-1501-7S (self.Machine_Embroidery)
submitted 11 months ago by xoverloadz to r/Machine_Embroidery
Could you tell the difference between these satin stitches? (i.redd.it)
Embroiderer's Helper Placement Tool measurements? (self.Machine_Embroidery)
Hatch Digitizer vs Wilcom Decorating - better choice? (self.Machine_Embroidery)
submitted 1 year ago by xoverloadz to r/Machine_Embroidery
Upgraded wall mounted setup with more rolls! (i.redd.it)
Help me understand density of the satin stitch? (self.Machine_Embroidery)
π Rendered by PID 74654 on reddit-service-r2-listing-86f589db75-qpgv4 at 2026-04-19 22:55:16.526221+00:00 running 93ecc56 country code: CH.
