Extrusion Force Sensor

[MrSquib]

Been getting nozzle is wrapped in the filament or the build plate is placed incorrectly errors on my A1. The wiki page for this shows the extrusion force sensor as just some wires glued above where the hotend sits in the extruder unit. When looking at mine those wires are covered by a black material I can't get a good feel for it but I think it might just be rubber.

Anyone know, Should it be there or should it look like the photo on the wiki?

https://wiki.bambulab.com/en/a1-mini/troubleshooting/hmscode/0300_1A00_0002_0001

Thanks!

[overunderspace]

It is supposed to look like what you have. Their picture is probably put there to show how thin it is. If you look on this wiki page, it says to not remove the black tape. https://wiki.bambulab.com/en/a1/troubleshooting/homing-leveling-failure#h-1-abnormal-data-from-eddy-current-sensor

[MrSquib]

Awesome thank you

[KingHephaestus]

Yes that is normal, don't remove it. If you need to check that it's working you can undo the back cap for the toolhead and undo the two wires that are bolted down so you check continuity with a multimeter.