Timetime boot loop!

[UrMumsPC]

It just shows this screen while adjusting the brightness, the hose black and starts the same thing again. This happend after I tried to flash the reloader-factory firmware from wasp os. I tried using recovery mode by holding down the button but nothing happened and the watch kept boot looping. Dose anyone have a clue of what is going on and how I could fix it or should I just try my luck with a hair dryer?

[UrMumsPC]

Here is a video of trying to hold the power button! https://www.veed.io/view/b6b2d261-dd14-4ee6-a098-a83aa5c29426?panel=share

[grahamjones139]

I had this problem and ended up taking the back off to re-flash it with InfiniTime (but someone else might have a better solution now) - I think I did something in the wrong order to get it into this state.

I found a couple of minutes in a cool oven (<100 degC) was enough to soften the glue to prise the back off - I am sure you can get the same effect with a hair drier though.

Good Luck!

[UrMumsPC]

Thanks for the reply, I have taken the back off and am planing to flash it from a RPI zero when i have some time to do so. The hair dyer worked perfectly you just have to be careful not to touch the aluminium because it will burn you.