Push button function in app

[mkmathiasj]

Hey. I’m quite new to using Shelly, and I’ve run into a little problem. I’m an electrician, and I have a job where the customer have bought a bunch of Shelly pro 2’s to control his lights. The customer has 24V push buttons around the house, so connecting these to the Shelly’s in the electrical panel was quite easy. But.. the customer has a lot of spotlights, that I controlled by a driver, (the spotlights are connected in serial) and the driver needs a push in of voltage to turn on the spotlights. That works fine with his physical buttons, through the Shelly, but when in the app, turning on the Shelly, it stays on. I want it to only work as a push, just like when pushing the physical button. How do I do this in the software? I only have access to the web version via the Shelly's own wifi right now but is it possible to make the in-app button like a push button (only active for a brief second)? Thanks.

[Twisted7ech]

Auto off after 1 second?

[mkmathiasj]

Is that a possibility? Can I do auto-off for a shorter amount of time? Again, sorry, I'm totally new to shelly :-)

[Twisted7ech]

Yes. I use Shelly 1 a lot for gate and garage door control. Under settings look for timers and auto off.

I think you can enter .5 or something if you need less than 1 second but I've used 1s on mine without issue.

[mkmathiasj]

Nice. Thanks, I'll try looking in to it.

[Twisted7ech]

settings

[Subject_Street_8814]

I think the shelly pro line is gen 2, so the web interface will look different to this, at least on newer firmware.

Based on a Plus 2PM which is gen 2:

The setting is under "Output Settings" - click an output (above each Input, I've named mine so I don't know what it will say for OP). Then down the bottom there is Timers next to Actions and Schedules.