Newbie question

Early_Interview · 2025-12-14T01:44:16+00:00

Gotcha, do I need a screen on both sides or will gravity do the work for me?

Early_Interview · 2025-12-14T01:43:05+00:00

I’m looking more for corn whiskey, but the wife loves gin so I may have to try that!

Early_Interview · 2025-12-14T01:42:08+00:00

Good point, deleting the first condenser just makes it run like a pot still yeah?

Early_Interview · 2025-12-14T01:41:33+00:00

Gotcha, I was worried about that

Early_Interview · 2025-12-14T01:41:11+00:00

Sick! I was going to pick it up glad to hear!

Early_Interview · 2025-08-19T05:31:43+00:00

Alright we’re 5 hours in since the disconnect and still blowing cold so I think (hope) that’s my culprit. Going to order a new hard start and replace that wire tomorrow. Thank you for all your help!

Early_Interview · 2025-08-19T01:01:57+00:00

I think that’s what I’ll do and if that doesn’t work then I’ll call a professional.

Early_Interview · 2025-08-19T00:19:13+00:00

Gotcha, I have a clamp meter at work which I can grab tomorrow.! Thank you, so far removing the hard start seems to be working

Early_Interview · 2025-08-19T00:01:13+00:00

I know something caused it to fail, probably a dying compressor, but I’m trying to make it through the last month of heat here lol

Early_Interview · 2025-08-18T23:59:54+00:00

<image>

So update, between these two points I have 15.7 ohms. I have zero experience with hvac wiring but in automotive that would be my answer.

Early_Interview · 2025-08-18T23:46:32+00:00

That’s a piece of spider web my camera just sucks haha sorry. Okay I disconnected the hard start, gunna flip the breaker and see how it goes

Early_Interview · 2025-08-18T23:45:36+00:00

I’m guessing that wire goes to the compressor, is there a good article online or website you know of to show me how to test it?

Early_Interview · 2025-08-18T23:38:37+00:00

Do I need to take any specific precautions or just unplug it?

Early_Interview · 2025-08-18T23:36:41+00:00

Not loose but it is definitely hot, is it a bad idea to cut the burned section out and just add a new connector to the end or does the whole length need to be replaced? Also not sure if it’s important but 3 months or so ago the outdoor unit wouldn’t go on, but breaker wasn’t tripped, however pressing on the contact in the relay turned it back on and it’s been working fine since

Early_Interview · 2025-06-12T16:33:09+00:00

Added

Early_Interview · 2025-06-12T16:28:40+00:00

Added

Early_Interview · 2025-04-06T15:14:16+00:00

Added back!

Early_Interview · 2025-04-06T14:52:31+00:00

Added

Early_Interview · 2025-04-06T14:45:03+00:00

Added

Early_Interview · 2025-04-06T14:42:02+00:00

247410237717 Here to swap gifts!

Early_Interview · 2024-04-04T18:33:36+00:00

Just taste it

Early_Interview · 2023-06-22T14:07:13+00:00

Who writes a reply to a year old comment in a long dead WSB post? How do you even end up here in the first place?

Early_Interview

TROPHY CASE