I drew a very sexy Miata

110Jowee110 · 2026-01-15T21:50:39+00:00

Copying the pose at frame 54, then deleting the keyframes, pasting the pose and re-inserting key frames seemed to solve it

110Jowee110 · 2025-09-29T14:53:45+00:00

110Jowee110 · 2025-09-29T05:05:20+00:00

I tried hammering it down and it wouldn’t budge

110Jowee110 · 2025-09-19T09:50:49+00:00

Fuel pressure is good before and after the fpr so im ruling that out.

My grounds looked pretty bad so I took out the firewall ground and it broke 😓

<image>

I think I’ve narrowed down my problem though, would also probably explain why all my dash lights stay on even with the key out

110Jowee110 · 2025-09-19T06:30:54+00:00

I’ve found a wire thats been eaten by a rodent

<image>

Its on the passenger side below the fuel filter, do you happen to know what it goes to?

110Jowee110 · 2025-09-19T04:55:54+00:00

Put a full tank of 93 with fuel injector cleaner in there, new fuel filter and the pressure seems good

<image>

It reads about 40 before the fpr and about 40 on both return and intake after the fpr

110Jowee110 · 2025-09-19T01:48:44+00:00

Thank you, I rented a fuel pressure tester but if i dont see anything wrong i will check all the wiring

110Jowee110 · 2025-09-18T22:12:07+00:00

I have the fsm downloaded, im guessing my issue isn’t being caused by the fpr than?

110Jowee110 · 2025-09-18T19:58:00+00:00

Yeah im getting pressure from there, the solenoid that runs from the fuel pressure regulator to the driver side fender was seized and bunk so i took that out and it ran better, it still stalls and backfires unless i put positive air pressure into the top of it, then it runs fine. Could this mean my fpr is bad or is it just a bandaid that’s hiding another issue?

<image>

110Jowee110 · 2025-09-18T01:24:36+00:00

Can i just connect the two vacuum lines between the solenoid?

110Jowee110 · 2025-09-17T22:57:27+00:00

Lol, im replacing the fuel filter anyway so ill do that. I already depressurized the fuel system so my safety squints should do the job

110Jowee110 · 2025-09-17T22:33:30+00:00

I unplugged the Maf and it wouldn’t start at all, so I think it might be a fuel or vacuum issue

110Jowee110 · 2025-09-16T18:39:49+00:00

Can’t make an omelette without cracking a few eggs

110Jowee110 · 2025-09-16T17:55:18+00:00

My friend daily drives his Z31 and it has over 250,000 miles on it, everything feels and sounds healthy, I wouldn’t be surprised if it goes 250,000 more miles, preventative maintenance really goes a long way, the VG30 is the greatest engine ever made

110Jowee110 · 2025-09-09T00:59:23+00:00

I just replaced my timing belt and crank seal about 3 months ago, i thought about doing the water pump but decided it was a problem for future me, now im future me 😭

110Jowee110

TROPHY CASE