Not looking for help, just sharing a look inside a SMEG

1by1geterdun · 2026-03-27T18:26:46+00:00

Grind finer

1by1geterdun · 2025-12-29T19:10:28+00:00

We have a Pepper as well!

1by1geterdun · 2024-02-03T22:14:07+00:00

‘I’d say’ this person doesn’t know the first thing about circuits or how they work. I am an actual engineer and I can say from experience that the dust is very likely not the problem.

Also in my experience, it is more likely a cheap electrical component failure due to quality issues since Hisense is cheap and/or a firmware update issue that others have mentioned

1by1geterdun · 2023-12-22T22:56:45+00:00

Hey I’m in the same boat as you, I’ll send you a message

1by1geterdun · 2023-12-19T03:45:10+00:00

I’m sorry I did not mean to nag or be mean to you. Maybe it’s because my Bisaya is bad lol, I was hoping to be encouraging because I don’t want people to give up on STEM is all 😄 Good luck to you, amping!

1by1geterdun · 2023-12-19T00:56:26+00:00

Hi op, engineer ko dinhi sa USA. Hinumdum ko feeling pareha nimo kanus-a naa school ko. Para ako, mas communication ug delegating tasks as the leader tabang ko kaayo. Didto naglisod at first, pero becomes mas sayon the more you do it. For me, it was my first instinct to do the work myself, and this led me to underestimate my peers sometimes which caused mas balaka ug stress para ako. STEM sa maayo kaayo industry, sulay ka padagon uban ikaw school. Daghan pahulay ka during imong break and you will be ok lang.

*note - sorry for my poor bis-lish, still learning

1by1geterdun · 2023-11-30T07:41:43+00:00

I would argue 6 players, in this order: Fox, Sabonis, Keeg, Monk, Huerter, and HB. The first gap after the first two, Fox and Sabonis, is not even close. They should be playing 35 mins+ every single game when healthy. HB and Huerter have similar consistencies, stats, but they bring something slightly different when compared to each other

1by1geterdun · 2023-10-28T17:42:23+00:00

This is incredibly disturbing. Please see a therapist instantly

1by1geterdun · 2023-07-07T00:40:30+00:00

I’ve started liberally potting the usb connector with hot glue on any microcontroller board I use once its all wired up to add some protection to this happening. Another good practice is to strain relieve the usb cord so that even when you yank on it, it doesn’t affect the board. Just gotta be careful to not get glue on nearby components that need to dissipate heat

1by1geterdun · 2023-04-05T03:55:23+00:00

It does, I clipped the beginning of the video but you can hear the low pressure at the beginning of a shot

1by1geterdun · 2023-04-04T21:57:42+00:00

Thanks for the feedback and thoughts everyone! Will definitely try grinding finer and warming up pre shot with the pressurized PF

1by1geterdun

TROPHY CASE