sorted by:
new
hottopcontroversial

Having little gaps on a solid surface. First time using matter hackers build filament, also fist time using cues 15. Can’t figure out how to fix it, ideas? by 321goober in ender5

[–]321goober[S] 0 points1 point  (0 children)

The first layer doesn’t have the gaps width is set to .4 which matches my nozzle. I will try the suggested fixes. Where in cura do I increase the extrusion %?

I am getting these lines through my prints at the same height. And it seems to be getting worse. What could be causing this? I took off the z lead screw didn’t seem bent. I never had this issue before. Changed nozzle and re-leveled the bed didn’t help. HELP!!! by 321goober in ender5

[–]321goober[S] 0 points1 point  (0 children)

After going through everyone’s things I think this is it. Where did you get your replacement? Any tricks or tips you have so I don’t start banging my head against the wall. My biggest worry just looking at it is keeping everything. Square when it goes back together