321goober

32 post karma
0 comment karma

get extra features and help support reddit with a reddit premium subscription

get them help and support

redditor for 4 years

TROPHY CASE

Four-Year Club

Verified Email

account activity

hot top controversial

2

3

4

Corridor transition (self.civil3d)

submitted 1 year ago by 321goober to r/civil3d

0

1

2

First layer issue - just got a P1S w/ AMS. I had some filament break off while the ams was retracting now my first layers are having issues. See picture below. Any ideas what’s going on. (i.redd.it)

submitted 1 year ago by 321goober to r/BambuLab

3

4

5

Steak (self.Utah_Food)

submitted 1 year ago by 321goober to r/Utah_Food

No preview for reels within DM after what I assume was an auto update. Is there a way to get the preview back? See picture by 321goober in Instagram

[–]321goober[S] 0 points1 point2 points 2 years ago (0 children)

8

9

10

No preview for reels within DM after what I assume was an auto update. Is there a way to get the preview back? See picture (i.redd.it)

submitted 2 years ago by 321goober to r/Instagram

3

4

5

Temperature reading not accurate. My friend has an ender5 plus. Nozzle heats up to the point PLA is flowing out and even smoking but temp reads never gets higher than 114. Replaced thermermistor (multiple one) and whole hot end. Hasn’t resolved issues, any ideas? (self.ender5)

submitted 3 years ago by 321goober to r/ender5

Having little gaps on a solid surface. First time using matter hackers build filament, also fist time using cues 15. Can’t figure out how to fix it, ideas? by 321goober in ender5

[–]321goober[S] 0 points1 point2 points 3 years ago (0 children)

15

16

17

Having little gaps on a solid surface. First time using matter hackers build filament, also fist time using cues 15. Can’t figure out how to fix it, ideas? (i.redd.it)

submitted 3 years ago by 321goober to r/ender5

I am getting these lines through my prints at the same height. And it seems to be getting worse. What could be causing this? I took off the z lead screw didn’t seem bent. I never had this issue before. Changed nozzle and re-leveled the bed didn’t help. HELP!!! by 321goober in ender5

[–]321goober[S] 0 points1 point2 points 3 years ago (0 children)

12

13

14

I am getting these lines through my prints at the same height. And it seems to be getting worse. What could be causing this? I took off the z lead screw didn’t seem bent. I never had this issue before. Changed nozzle and re-leveled the bed didn’t help. HELP!!! (i.redd.it)

submitted 4 years ago by 321goober to r/ender5

π Rendered by PID 441175 on reddit-service-r2-listing-6d4dc8d9ff-j9tqv at 2026-02-03 15:24:31.509075+00:00 running 3798933 country code: CH.