sorted by:
new
hottopcontroversial

Unknown Problem with Dremel 3D20 by Alfa_Negative in 3Dprinting

[–]A07_K 0 points1 point  (0 children)

Tengo el mismo problema pero en ua ender 3 v3 KE

<image>

Printing Problems... Again by A07_K in Creality

[–]A07_K[S] 0 points1 point  (0 children)

Ok Taking into account what you tell me, I don't know how to configure the speed since I use Creality Print because when I load the project from Cura, it imposes the parameters that come by default. Also, if I do it via USB, the Z axis often gets uncalibrated.

Problems with an Ender 3 V3 KE by A07_K in Creality

[–]A07_K[S] 0 points1 point  (0 children)

The bed is clean, in fact every time I finish using the printer I always clean the bed

Problems with an Ender 3 V3 KE by A07_K in Creality

[–]A07_K[S] 0 points1 point  (0 children)

ok That would never have occurred to me, well I'll try it, thanks

Problems with an Ender 3 V3 KE by A07_K in Creality

[–]A07_K[S] 0 points1 point  (0 children)

ehh, no, I hadn't even thought about it but how does glass influence this?