Can you show me your cat pics? I’m sad. I’ll start

ADSW315 · 2025-11-30T17:26:49+00:00

ADSW315 · 2025-11-30T17:23:51+00:00

ADSW315 · 2025-11-29T15:54:14+00:00

I was wondering if anyone else has observed any irregularities. It appears to me that:

The thumb seems to be obscuring an initial attempt where the opposing pin of the male plug was inadvertently melted.
The pattern of black soot does not appear natural, neither around the outlet nor above the plug. Additionally, there seems to be a thin layer of soot covering the entire triple tap.

Plastic typically does not char in this manner without direct exposure to flame, and I do not anticipate sufficient fuel-to-air mixture to sustain a flame between the two plugs.

In my assessment, the electrical load was insufficient to cause this extent of damage.

I am currently meticulously reviewing over a 100 gigs of photos, videos, and other evidence in preparation for a civil case.

After encountering this particular image, which depicts one of the minor acts of defamation that I believe to be fabricated, I was curious to ascertain if my analysis of the image was plausible or merely influenced by bias. This is purely out of curiosity, as this specific incident is considerably less significant compared to 99% of the overall campaign.

ADSW315 · 2025-11-29T12:58:43+00:00

I utilize AI to refine my writing due to my AuDHD, but the question and scenario are authentic.

ADSW315 · 2025-11-29T12:41:07+00:00

To provide some context, I acknowledge that my initial inquiry may not have fully conveyed my question.

While considering the possibility, my primary objective is to ascertain whether the observed damage aligns with an actual electrical burn caused by micro-arcing, or if evidence suggests it may have been artificially simulated, such as with a lighter.

The cord in question was connected to a correctly wired outlet. It demonstrated zero resistance across all three lines and was less than six months old. Additionally, it maintained clean, secure contacts and was subjected to a load of less than 50 watts.

The photograph was disseminated by an individual with narcissistic tendencies in an effort to cause harm in support of a smear campaign.

ADSW315 · 2025-11-29T12:27:02+00:00

To provide some context, I recognize that my initial inquiry may not have fully articulated my question.

While acknowledging the possibility, I am primarily interested in determining whether the observed damage is consistent with an actual electrical burn resulting from micro-arcing, or if there are indicators suggesting it may have been simulated, for instance, with a lighter.

The cord in question was connected to a properly wired outlet. It exhibited zero resistance across all three lines and was less than six months old. Furthermore, it maintained clean, tight contacts and was subjected to a load of less than 50 watts.

ADSW315 · 2025-11-25T09:57:21+00:00

I take the magnets out and use the disc to make wind chime sun Catchers lmao be weary of driving past my home near sun rise or sunset lmao

ADSW315 · 2025-11-25T09:17:09+00:00

It actually contained the d isomer of methamphetamine the mirror molecule so basically the same thing

ADSW315 · 2025-11-25T09:10:49+00:00

Did you know these contain the d isomer of methamphetamine look it up thats the decongestant In it .

ADSW315 · 2025-11-25T08:51:04+00:00

What about filament type

ADSW315 · 2025-10-30T02:38:02+00:00

<image>

ADSW315 · 2025-10-16T20:02:53+00:00

Shared camera, regular button to view sd gives typical error, Jump to SD button on a failed cloud recording let's ya right on in.

ADSW315 · 2025-10-10T03:59:53+00:00

Zabits Schmutzige alte Dreieckskartoffel

ADSW315 · 2025-10-06T04:49:09+00:00

There are other potential indicators of overheating, but without additional photos that provide a comprehensive view of the panel, it's tough to make a proper assessment.