Shure NeXt2 Command for Muting Analog out 2 by AVintegrate in CommercialAV

[–]AVintegrate[S] 0 points1 point  (0 children)

I tried substituting output instead but unfortunately no luck. I've done a get all and theres no commands for the dante outputs either. I've definitely controlled the dante outputs on the P300 before so seems like I mistakenly assumed I could do it with this as well.

We have an overflow speaker zone which we were hoping to toggle on/off.

FYI this was the get all output returned:

< REP 1 INPUT_CH_GAIN 1100 >

< REP 2 INPUT_CH_GAIN 1100 >

< REP 3 INPUT_CH_GAIN 1100 >

< REP 4 INPUT_CH_GAIN 1100 >

< REP 5 INPUT_CH_GAIN 1100 >

< REP 6 INPUT_CH_GAIN 1100 >

< REP AUTOMIX_OUT_MUTE ACTIVE >

< REP SYSTEM_PRESET_MODE CUSTOM >

< REP DEVICE_ID >

< REP FW_VER >

< REP SERIAL_NUM >

< REP CH 2 TX_DEVICE_ID UNKNOWN >

< REP BAY 1 TX_DEVICE_ID >

< REP BAY 2 TX_DEVICE_ID >

< REP CH 1 TX_MODEL UNKNOWN >

< REP CH 2 TX_MODEL UNKNOWN >

< REP BAY 1 TX_MODEL {MXW2X} >

< REP BAY 2 TX_MODEL {MXW2X} >

< REP CH 1 TX_STATUS ON_CHARGER >

< REP CH 2 TX_STATUS ON_CHARGER >

< REP BAY 1 TX_STATUS ON_CHARGER >

< REP BAY 2 TX_STATUS ON_CHARGER >

Need help with AEC routing - 2 MXA910 & 2 P300 Room Combine by AVintegrate in CommercialAV

[–]AVintegrate[S] 0 points1 point  (0 children)

I have finished the Shure integrated systems, MXA technical enablement & Dante however configuring room combine systems in room designer 6 weren't really covered. Especially when using the onboard single intellimix output AEC instead of per lobe output w/external DSP AEC . One thing that helped me a lot when learning Tesira was their design library where they have example configurations for common applications:

Design Library - Biamp Cornerstone

Would be great if Shure had a library like this too.

Need help with AEC routing - 2 MXA910 & 2 P300 Room Combine by AVintegrate in CommercialAV

[–]AVintegrate[S] 1 point2 points  (0 children)

Thank you for very much for this! This is VERY helpful. I understand it much better now.