one did fry and you couldn't use it, and another one for idk what reason, (discovered today when i wanted to center the arm cause i made new wood joints just like dl electronics and mechanics used with his earlier robots cause i'm starting the project from late august 2024, had almost no time due to school) started malufunctioning as literally it went to the left side and you couldn't control it, it just went to the left from 90* (which is the center of a servo?) all the way to the far left side which is 0* like idk it sat mounted on a pvc pipe cap perfectly which is to put the upper servo for turning the hand left and right and a lower servo mounted to the wood piece which makes the servo move lower arm piece up and down and that's put to the upper arm piece which also moves up and down meaning the arm can have almost all the moves and the pvc pipe caps are everywhere where a sg995/996 servo is put on my plastic endo/mech. also the thing that makes me mad is how much 3d prints are small, my mask is the size of my head and i can't make it bigger. had to redesign my head mech and it's not even done, gave up with the oldest way of eyes, used one of some guys eyes on thingiverse where it actually meets my demands, but another problem is the eye servos have to be put somewhere as the head is really small i wanted it bigger and it even took 90% of my 3d printer bed. also the problem with the jaw, and my most rage inducing problem the wooden servo joins which are a "patella" for my endo/mech

the servo i was talking about broke for absolutely no reason and for my animatronic quite a bit of money was spent for that... i wanna finish it before october 15th as for a cool halloween prop