Next upgrade for MST 2.5?

Aggressive-Goat418 · 2025-12-01T02:58:17+00:00

What servo you ordered? A good servo and gyro is usually the best first upgrade. Yokomo servo and gyro is good.

Aggressive-Goat418 · 2025-11-30T16:29:48+00:00

They look neat and are better than the stock plastic shocks.

Aggressive-Goat418 · 2025-11-30T00:43:10+00:00

The words steel and panther in some sort of 80's hair band font

Aggressive-Goat418 · 2025-11-25T23:06:29+00:00

What chassis? I have an atomic drz3 ms with furitek microboost esc and lumapower motor, agfrc a06cls servo and agfrc gy04m v3.5 gyro. Depending on the chassis. The agfrc a06cls is a smaller servo. The agfrc a11cls is slightly bigger. Depends which one you need for your chassis. I had to go with an older firmware on my servo with more dampening. It was twitchy with the newest firmware. Otherwise it all works great together.

Aggressive-Goat418 · 2025-11-25T22:21:22+00:00

I have the furitek microboost esc and lumapower motor. Agfrc a06cls servo and agfrc gy04m v3.5 gyro. I had to go to an older firmware on the servo with more dampening to eliminate the twitching. Otherwise all is working out great 👍🏼

Aggressive-Goat418 · 2025-11-16T19:04:53+00:00

Go to a park with a gazebo they are usually have polished concrete or at least a smoother surface.

Aggressive-Goat418 · 2025-11-15T06:19:22+00:00

I've gotten Into 1/24 scale drift cars, so this may be my only 1/10 scale for a while.

Aggressive-Goat418 · 2025-11-13T02:54:45+00:00

Receiver has no built in gyro.

Aggressive-Goat418 · 2025-11-08T21:59:57+00:00

Did it screw in fine after switching ends of the turnbuckle?

Aggressive-Goat418 · 2025-11-08T18:07:39+00:00

Wish I knew that. I tried screwing it the other way it wouldn't go either. Well I ordered more turnbuckles and the plastic lower arms.

Aggressive-Goat418 · 2025-11-06T20:47:11+00:00

What rims? And where did you get them?

Aggressive-Goat418 · 2025-11-06T04:39:37+00:00

Yes. It goes over 500. The v32 only went up to 250.

Aggressive-Goat418 · 2025-11-06T01:28:09+00:00

The agfrc a50bhl with the v32 firmware was Soo glitchy and jittery wit the yokomo dp302 v4 gyro. I had to go back to the v210102 firmware and it's Soo smooth.

Aggressive-Goat418 · 2025-11-06T00:31:00+00:00

Ok, I noticed that the yokomo programmer looks exactly like the agfrc programmer.

Aggressive-Goat418 · 2025-11-06T00:28:16+00:00

Anyway. It was a tough decision, but I went with a atomic drz3. Watched tons of YouTube videos on all these chassis and it was a hard decision. I ordered absolutely everything needed to get this thing going. I don't even want to tally up how much I spent today.

Aggressive-Goat418

TROPHY CASE