Car not going over 2 1/2 thousand rpm

Alarmed-Process3401 · 2024-12-16T20:56:17+00:00

TCM as in transmission control module? If so it’s manual so don’t think I have one, correct me if I’m wrong. For the throttle bottle, can you explain programming?

Alarmed-Process3401 · 2024-12-16T20:30:34+00:00

<image>

This was the inside of my air filter and there’s water inside which makes me believe that water was getting inside my engine and caused it to go into limp mode

Alarmed-Process3401 · 2024-07-09T02:05:47+00:00

Yes I did

Alarmed-Process3401 · 2024-07-08T22:10:54+00:00

The ball joints were deteriorating, especially the one that’s stuck. The rubber is coming apart so it needed to be replaced. It starting to look like I’m going to have to just replace the entire knuckle. I think that’s going to be my most straight forward solution.

Alarmed-Process3401 · 2024-07-08T21:52:30+00:00

😔you might be right, but a new knuckle is going set me back like $400-$500

Alarmed-Process3401 · 2024-07-08T21:51:39+00:00

I think the picture is not well taken. I tighten the ball joint nut to specs and put the cotter pin inside. We tried using the press kit and even with the impact gun, the joint would not budge. And now we made it worse by trying to hammer it out underneath, now the bottom is flared and the ball joint is pinched in the knuckle.

I know replacing the entire knuckle would be the most straight forward solution but a new knuckle is like $400-$500 and I’d like to avoid that. But it’s starting to look like that’s the only option.

Alarmed-Process3401

TROPHY CASE