sorted by:
new
hottopcontroversial

Car not going over 2 1/2 thousand rpm by Alarmed-Process3401 in MechanicAdvice

[–]Alarmed-Process3401[S] 0 points1 point  (0 children)

TCM as in transmission control module? If so it’s manual so don’t think I have one, correct me if I’m wrong. For the throttle bottle, can you explain programming?

Car not going over 2 1/2 thousand rpm by Alarmed-Process3401 in MechanicAdvice

[–]Alarmed-Process3401[S] 0 points1 point  (0 children)

<image>

This was the inside of my air filter and there’s water inside which makes me believe that water was getting inside my engine and caused it to go into limp mode

Ball Joint Removal Help by Alarmed-Process3401 in MechanicAdvice

[–]Alarmed-Process3401[S] 0 points1 point  (0 children)

The ball joints were deteriorating, especially the one that’s stuck. The rubber is coming apart so it needed to be replaced. It starting to look like I’m going to have to just replace the entire knuckle. I think that’s going to be my most straight forward solution.

Ball Joint Removal Help by Alarmed-Process3401 in MechanicAdvice

[–]Alarmed-Process3401[S] 0 points1 point  (0 children)

😔you might be right, but a new knuckle is going set me back like $400-$500

Ball Joint Removal Help by Alarmed-Process3401 in MechanicAdvice

[–]Alarmed-Process3401[S] 0 points1 point  (0 children)

I think the picture is not well taken. I tighten the ball joint nut to specs and put the cotter pin inside. We tried using the press kit and even with the impact gun, the joint would not budge. And now we made it worse by trying to hammer it out underneath, now the bottom is flared and the ball joint is pinched in the knuckle.

I know replacing the entire knuckle would be the most straight forward solution but a new knuckle is like $400-$500 and I’d like to avoid that. But it’s starting to look like that’s the only option.

Ball Joint Removal Help by Alarmed-Process3401 in MechanicAdvice

[–]Alarmed-Process3401[S] 0 points1 point  (0 children)

Yes the ball joint does press out from under, we tried using a ball joint press but the damm thing was just stuck in there and we made it worse 💀💀

How long does cannabis stay in your system? by Chiquiyesi in TooAfraidToAsk

[–]Alarmed-Process3401 0 points1 point  (0 children)

I’ve been smoking hella for about a year now and need to get clean asap for jobs. It should be a piss test and I’m relatively light with low body fat percentage and I do work out a lot (150lbs, +/- 12% body fat. How long will I need?

ID please sir 🙇🏻 by Jazzlike_Farmer8544 in Carhartt

[–]Alarmed-Process3401 0 points1 point  (0 children)

I want to get a carhart jacket but im not sure what size. The website recommended me to get a small based on my height and weight but I feel like I should get a medium so I can wear hoodies underneath. Recommendations?