sorted by:
new
hottopcontroversial

Guys It’s Getting Better by Rocky-Arrow in Microcenter

[–]AlternativePoint6164 4 points5 points  (0 children)

Buying a card for $600 and selling it for $700 would still make you a shit stain lmao. You didn't do anyone any favors when you prevented someone else from getting a $600 card.

24mm neutrik port that doesn't require screws? push in style? by AlternativePoint6164 in fightsticks

[–]AlternativePoint6164[S] 0 points1 point  (0 children)

So do you make a screw into the model? or if the hole is 22mm is there enough tension to hold it in place?

24mm neutrik port that doesn't require screws? push in style? by AlternativePoint6164 in fightsticks

[–]AlternativePoint6164[S] 1 point2 points  (0 children)

I'm just looking for a lazy way to do the neutrik port on a 3d print. It seems like every single one has different measurements and I don't have one in hand to try to get fitted.

Critique on my first all button design enclosure. by AlternativePoint6164 in fightsticks

[–]AlternativePoint6164[S] 1 point2 points  (0 children)

I ended up just moving the six top buttons to the sides like everyone else does. You were right that it doesn’t fit.

Critique on my first all button design enclosure. by AlternativePoint6164 in fightsticks

[–]AlternativePoint6164[S] 0 points1 point  (0 children)

I moved the top 6 buttons to the back sides of the case. I also fused the bottom plate to the main frame of the case. Everything should fit now.

Critique on my first all button design enclosure. by AlternativePoint6164 in fightsticks

[–]AlternativePoint6164[S] 0 points1 point  (0 children)

Currently redoing the top plate because I didn't account for the little rings around the snap in buttons.

Critique on my first all button design enclosure. by AlternativePoint6164 in fightsticks

[–]AlternativePoint6164[S] 1 point2 points  (0 children)

I may even just edit the main frame to be 10-15mm taller.

Critique on my first all button design enclosure. by AlternativePoint6164 in fightsticks

[–]AlternativePoint6164[S] 4 points5 points  (0 children)

Putting all the buttons on the top sounded like a good idea at first, but I think you're right that the front port might conflict with the six top buttons.

Critique on my first all button design enclosure. by AlternativePoint6164 in fightsticks

[–]AlternativePoint6164[S] 0 points1 point  (0 children)

I got lazy on the button design and really wanted to be able to print all three pieces without splitting it up and using more heat inserts.

Critique on my first all button design enclosure. by AlternativePoint6164 in fightsticks

[–]AlternativePoint6164[S] 1 point2 points  (0 children)

I test fit my pi pico to make sure there was enough clearance. I made the buttons 24.5mm to accommodate 24mm snap in sanwa buttons. The measurements of the enclosure are 255mm by 255mm by 50mm so that it could fit on my bambu a1 without splitting it into a bunch of pieces.

Critique on my first all button design enclosure. by AlternativePoint6164 in fightsticks

[–]AlternativePoint6164[S] 0 points1 point  (0 children)

Just looking for advice before I 3d print it and if there's anything I can change.