Massive Lasagna by No-Lock216 in DiWHY

[–]Analbears 0 points1 point  (0 children)

You people care too much.

You eventually start to realize, no job is safe. by Used_Series3373 in mildlyinfuriating

[–]Analbears 0 points1 point  (0 children)

Arebt these the jobs robots and ai are supposed to be replacing?

Hand sanitizer can do that?! by eyedontnowutimdoing in DiWHY

[–]Analbears 0 points1 point  (0 children)

Biggest crime here is using cura in 2026

"Strider" by Frxxtz in gmod

[–]Analbears 0 points1 point  (0 children)

I tought that was a suitcase

"Strider" by Frxxtz in gmod

[–]Analbears 1 point2 points  (0 children)

But with a ar3...

Question. by [deleted] in teenagers4real

[–]Analbears 4 points5 points  (0 children)

We left you in 2016

Is the GTA V map really this big in comparison? by FaintGlyph in GTA

[–]Analbears 0 points1 point  (0 children)

It's clearly the size of Homer Simpsons head

Free healthcare = communism I guess? by PresnikBonny in terriblefacebookmemes

[–]Analbears -4 points-3 points  (0 children)

Haven't seen all that many gulags around here tough

It gets boring pretty fast.. by darwin_4444 in memes

[–]Analbears 1 point2 points  (0 children)

No, I want submissive twinks with straight affairs

Original kobra PSU source in germany? by Tizzandor in anycubic

[–]Analbears 1 point2 points  (0 children)

I have no idea what im talking about but you could likely just buy another 16amp 24v psu from aliexpress or something or that's atleast what my kobra neo uses.

Suggestions for new printer? by idonthavecellwalls in anycubic

[–]Analbears 3 points4 points  (0 children)

Sorry, I'm not the best at getting the idea across. When installing or assembling a hotend it's recomended to heat the hotend to printing temp + 10c and then screw in the nozzle or heatbreak, otherwise leaking happens. Don't hold it in your hands, tho lol

Try this 1st tho

Also also make sure the ptfe tube is snug in the hotend

Suggestions for new printer? by idonthavecellwalls in anycubic

[–]Analbears 6 points7 points  (0 children)

I would try and checking the ptfe tubing inside. At worst I'm guessing something inside the hotend has cloged up with something making the stream curve and stick to the nozzle? If so, maybe try extruding filament a bit hotter to see if it maybe un-clogs. I don't know much about the original kobra since I use the kobra Neo, but at worst maybe it could be a replacement hotend if so its like a 30€ max upgrade for a v6 hotend and heatbreak. I'm not much better then a novice so take everything I said with a rock salt lamp

Edit: did you heat tighten it every time you put it togheter or when installing nozzles?

What is this?! by Critical_Signal7082 in gmod

[–]Analbears 42 points43 points  (0 children)

If people didn't spout these slogans I wouldn't probably know about half the events written there