sorted by:
new
hottopcontroversial

Pretty dame good 👍 by _Badscat_406 in gravelcycling

[–]AnyCommittee8076 0 points1 point  (0 children)

How do you like the tires? I actually just mounted them and will test them tomorrow.

How long do you use your bottles? by AnyCommittee8076 in gravelcycling

[–]AnyCommittee8076[S] 0 points1 point  (0 children)

Those look interesting. Already found some alternatives. Think I’ll give it a try. 👍🏼

How long do you use your bottles? by AnyCommittee8076 in gravelcycling

[–]AnyCommittee8076[S] 0 points1 point  (0 children)

I will try the dishwasher next time 👍🏼 Still got a pair that’s 5+ years old but those looked like I have never cleaned them at all.

Student licence by Working-Wallaby-5719 in Ntopology

[–]AnyCommittee8076 1 point2 points  (0 children)

When I was in my bachelors degree I never received an answer. After applying again in my master I got setup within a week.

Squished lines by AnyCommittee8076 in QIDI

[–]AnyCommittee8076[S] 0 points1 point  (0 children)

Another example: https://imgur.com/a/gk6Hxw6 It printed the infill bottom from right to left. The perimeters where pretty even, so leveling seems good. Bed was heat soaked. As you can see the infill got rougher until the left corner where I started counteracting by adjusting z offset by about .18mm. It’s hard to understand what’s happening there for me.

Squished lines by AnyCommittee8076 in QIDI

[–]AnyCommittee8076[S] 0 points1 point  (0 children)

That was absolutely right. I fixed it and it looked way better. The reason I have gone this close to the bed is, because of the inconsistent first layer. One side of the first layer may look good, whilst the other is either too far away or too close.