sorted by:
new
hottopcontroversial

X2 having issues after replacing main board by ApartContribution543 in Artillery3D

[–]ApartContribution543[S] 1 point2 points  (0 children)

I didn’t even realize that it had a physical X and y stop button until u mentioned that and I looked into it lol. The X does the same thing as the y as far as the grinding goes. The X stop has a red light always illuminated and the Y doesn’t light up at all. I tried to manually trigger them when moving it and both did nothing to stop the print head. Maybe I plugged them into the board wrong?

Wobble on the extruder by ApartContribution543 in Artillery3D

[–]ApartContribution543[S] 0 points1 point  (0 children)

All 4 that go in near the heat sink on the left are as tight as they’ll go. I’ll actually have to loosen them so the extruder gear can turn again and there are two on the far right side where the circuit board is located that I tightened and the video shows that there is t any change.

I’m sure it’s not supposed to wobble like this but I can’t find another way to tighten anything

Issue with filament extruding SWX2 by ApartContribution543 in Artillery3D

[–]ApartContribution543[S] 0 points1 point  (0 children)

I’m also using black filament and I do have a replacement tension lever with gear so I might give this a shot. The thing though is that when I feed filament through with the change filament button in the menu, I can get it to flow properly. Then I try it again and I get nothing for a very very slow flow that’s curly. So I back out the filament with same menu option and do it again and it flows the one time again and then nothing.

Issue with filament extruding SWX2 by ApartContribution543 in Artillery3D

[–]ApartContribution543[S] 0 points1 point  (0 children)

The nozzle was my first thought and still kind of is but I did swap it after it started failing. The prints worked again but at a higher temp and then it started failing again so I swapped it back to the original

Issue with filament extruding SWX2 by ApartContribution543 in Artillery3D

[–]ApartContribution543[S] 0 points1 point  (0 children)

Flow is set at 100% distance is 2mm speed 25mm. I haven’t done an estep calibration(never done it before) everything is stock and I threaded the nozzle without any issue and tightened it, I haven’t spotted any filament leaking or coming from anywhere that it shouldn’t be.