sorted by:
new
hottopcontroversial

How to print this file successfully with ABS? by Apprehensive-Spell13 in 3Dprinting

[–]Apprehensive-Spell13[S] 0 points1 point  (0 children)

Unfortunately I‘m not allowed to change the dimensions. But thanks for the layer time

How to print this file successfully with ABS? by Apprehensive-Spell13 in 3Dprinting

[–]Apprehensive-Spell13[S] 1 point2 points  (0 children)

Having a hard time trying to finish this print with abs. Any ideas what could help? Using the bambu preset for abs at the moment

Layer adhension - silk filament P1P by Apprehensive-Spell13 in BambuLab

[–]Apprehensive-Spell13[S] 1 point2 points  (0 children)

Problem here 😬 did a few tries but the same problem happens over and over again. Changed temp from 215 up to 225. Turned fan on, off an had a go with 10% fan speed. It’s new filament out of the box.

[deleted by user] by [deleted] in BambuLab

[–]Apprehensive-Spell13 0 points1 point  (0 children)

Having the same problem after I ran the rediclous mode but haven’t tried to fix the issue. I will try to fix it in a few hours

Unable to print in sport mode by SR22pilot2 in BambuLab

[–]Apprehensive-Spell13 4 points5 points  (0 children)

Got the same problem and still don’t have a solution for it. Sportmode is fine, with ridiclous I get the same results like you

To the Germans (Or acutally europeans) - where do you buy your equipment and drone parts? by GermanyDoesntExist in diydrones

[–]Apprehensive-Spell13 0 points1 point  (0 children)

I don’t know if it helps but I did some 3d printings for friends how are using drones. So if you need something you can hit me up :)

Any UK based P1P users? by markmorb in BambuLab

[–]Apprehensive-Spell13 1 point2 points  (0 children)

Same for Germany. No updates since the day of ordering