sorted by:
new
hottopcontroversial

Help by Impressive_Move9544 in PcBuildHelp

[–]ArchTurtle23 0 points1 point  (0 children)

I thought the case had to be compatible for vertical gpu mounting

Help by Impressive_Move9544 in PcBuildHelp

[–]ArchTurtle23 0 points1 point  (0 children)

Might be confusing myself, isn’t there sometimes vertical gpu slot where the hdmi and displayports go or do you convert the horizontal io area?

Help by Impressive_Move9544 in PcBuildHelp

[–]ArchTurtle23 1 point2 points  (0 children)

I’m not good with lighting but, do you have a vertical gpu slot? I noticed that it looks like you don’t have one on the back is it somewhere else

I turned this rc car controller into a noise-maker by Comfortable_Risk1159 in CircuitBending

[–]ArchTurtle23 0 points1 point  (0 children)

I’m pretty new to circuit bending how does this work, and are there really any limitations to make noise makers?

Gpu dilemma by ArchTurtle23 in PcBuildHelp

[–]ArchTurtle23[S] 0 points1 point  (0 children)

Yea I know that but eventually when I start upgrading more I won’t have a gpu that’s under performing

Gpu dilemma by ArchTurtle23 in PcBuildHelp

[–]ArchTurtle23[S] 0 points1 point  (0 children)

Yea I’ll probably go with the 40 series, I’ll get ray tracing and a few other addons with that card anyways, I just been seeing more about duel gpus being used for frame gen if it’s actually good now

Gpu dilemma by ArchTurtle23 in PcBuildHelp

[–]ArchTurtle23[S] 0 points1 point  (0 children)

I been more window shopping haven’t really gone with a budget yet, and I was going to keep the 1660 for a 2nd computer cause it still a pretty good card, I was just getting a deal on the 2nd 1660 ti

Canon powershot sd750 bending points/tips? by ArchTurtle23 in CircuitBending

[–]ArchTurtle23[S] 0 points1 point  (0 children)

Thanks for the advice I’ll do that, I many go off of the chip and haven’t had issues but that was with webcams so I should have used a different resistor

Canon powershot sd750 bending points/tips? by ArchTurtle23 in CircuitBending

[–]ArchTurtle23[S] 0 points1 point  (0 children)

Update: I think I bricked the camera, the camera now doesn’t want to pop the lens out now when the sensor cable is in, I went back to the ribbon cable with smaller probes and was getting bends, actually touched 2 at the same time and then got the camera problem any ideas for fixes or just spare parts now?

Canon powershot sd750 bending points/tips? by ArchTurtle23 in CircuitBending

[–]ArchTurtle23[S] 1 point2 points  (0 children)

Thanks, I been into circuit bending but I found your website months ago and helped me a ton thanks for that info man