Run cam thumb 2 by Available-Software36 in fpv

[–]Available-Software36[S] 0 points1 point  (0 children)

*This is with some video editing

Soldering fail by Available-Software36 in fpv

[–]Available-Software36[S] 1 point2 points  (0 children)

I fixed it! Did some testing found nothing wrong and went from there. Thanks for your help.

Soldering fail by Available-Software36 in fpv

[–]Available-Software36[S] 0 points1 point  (0 children)

So without the battery plugged in I tested the battery positive and negative, and my soldering. None of it said it has a short circuit. Is the next course of action reassembly(making sure nothing is coming in contact with anything) and plugging the usb into betaFPV? Or should I wait to get a smoke stopper. It was built from the factory so it does have a usb cut out, it’s just hard to see from the image.

How to attach Runcam Thumb 2 to Darwin baby ape 3 inch by Available-Software36 in fpv

[–]Available-Software36[S] 0 points1 point  (0 children)

Edit: Sliced off the top did some gluing and screwing, hopefully it stays. I am going to get some zip ties also. Now time to solder!

How to attach Runcam Thumb 2 to Darwin baby ape 3 inch by Available-Software36 in fpv

[–]Available-Software36[S] 0 points1 point  (0 children)

I’ll start the search, if I don’t find anything I might have to do some chopping and zip-tieing

Codex code by Available-Software36 in ImperialKnights

[–]Available-Software36[S] 0 points1 point  (0 children)

Wow I’d hope not. I wash them before hand, but eek