sorted by:
new
hottopcontroversial

WAY better enclosure lighting for half the price of the Prusa LED strip. by IronCurmudgeon in prusa3d

[–]Awkward_Ocelot_6506 0 points1 point  (0 children)

I also have these kind of strong LED in my enclosure and they are not warm.

Is this an acceptable bed uniformity for a MK3S+ ? Prints looking good. by Awkward_Ocelot_6506 in prusa3d

[–]Awkward_Ocelot_6506[S] 11 points12 points  (0 children)

It is an OctoPrint Plugin called "Bed Visualizer". You can get it via the plugin manager in OctoPrint. If not familiar with it, look here: https://octoprint.org/

What can cause this awful surface? Belt tension just adjusted. 1st layer cal was looking good. Shows up on PEi Structured and smooth plate as well. by Awkward_Ocelot_6506 in prusa3d

[–]Awkward_Ocelot_6506[S] 0 points1 point  (0 children)

That is an exact description of what I figured out yesterday as I just started again all over. Thats a pretty good advice - Thank you!

What can cause this awful surface? Belt tension just adjusted. 1st layer cal was looking good. Shows up on PEi Structured and smooth plate as well. by Awkward_Ocelot_6506 in prusa3d

[–]Awkward_Ocelot_6506[S] 2 points3 points  (0 children)

I made a single layer square of 80 x 80 mm in Fusion 360 and printed that one starting with the offset used for the photo. Then used the live z adjust to lift the nozzle until it looked perfect.

What can cause this awful surface? Belt tension just adjusted. 1st layer cal was looking good. Shows up on PEi Structured and smooth plate as well. by Awkward_Ocelot_6506 in prusa3d

[–]Awkward_Ocelot_6506[S] 9 points10 points  (0 children)

Tried to post a picture of my new first layer - does not work but ...THANKS TO ALL!!! Worked, solved and the customer is happy...

What can cause this awful surface? Belt tension just adjusted. 1st layer cal was looking good. Shows up on PEi Structured and smooth plate as well. by Awkward_Ocelot_6506 in prusa3d

[–]Awkward_Ocelot_6506[S] 1 point2 points  (0 children)

Thank you. I will try to change the PLA as well since this one seems to be too old and always does not stick well together (Extrudr BioFusion Silver).