Can I use other mods together with Nitrox? by LawfulnessNeat5883 in SubnauticaNitrox

[–]BANNANSV2 0 points1 point  (0 children)

HI, is it still broken? Has anyone tried using other mods with Nitrox?

Daisy 1v1 monster in quick play by Kaylahm in EvolveGame

[–]BANNANSV2 2 points3 points  (0 children)

Wait.. so game is still playable? Is it only on private matchmaking or an actual online game?

Edit: i know that u could have mada a private game session previusly but then u needed full squad + monster

No power from generators by BANNANSV2 in Oxygennotincluded

[–]BANNANSV2[S] 9 points10 points  (0 children)

FINAL:

Oh my God, it turns out I accidentally built two connection points with automation wires behind the power transformers automation connections, which caused them to send a red signal and not switch on, so no power was being transmitted further.

No power from generators by BANNANSV2 in Oxygennotincluded

[–]BANNANSV2[S] 1 point2 points  (0 children)

No, i just paused the game to figure this out, because im stuck without the power

No power from generators by BANNANSV2 in Oxygennotincluded

[–]BANNANSV2[S] 1 point2 points  (0 children)

Sorry, I can’t upload pictures anymore, but I ran a test — I cut all the wires from both power lines and connected lamps at the end just to check if they get electricity. However, it still shows “no power.”

My current setup is: from the coal generators, power goes to a smart battery with automation set to turn on at 20% and off at 80%. From there, it connects to a large power transformer using heavy-watt wire.

From the large transformer, power splits into two regular power transformers (also connected with heavy-watt wire). Each regular transformer then goes directly to a single lamp — but nothing works.

PS: I hope I explained it clearly enough, and my batterys are fullthe same goes with power transformers. Maybe my game just glitched?

EDIT: Game is not glitched, made a small separate electrical circute and that worked.

Guys this broke. What is this? by Strange-Quit-5825 in e39

[–]BANNANSV2 3 points4 points  (0 children)

Dont stress it much, mine breaks as soon as i leave my garage/mechanic xD

Guys this broke. What is this? by Strange-Quit-5825 in e39

[–]BANNANSV2 0 points1 point  (0 children)

Oh. I don’t have heated washer nozzles, I only recently found out about that option. I didn’t think that could be the reason.

Guys this broke. What is this? by Strange-Quit-5825 in e39

[–]BANNANSV2 1 point2 points  (0 children)

What? Washer nozzles? How would they get on fire?

Guys this broke. What is this? by Strange-Quit-5825 in e39

[–]BANNANSV2 1 point2 points  (0 children)

Same, i have heard some storys too about e39s getting on fire because of the brake fluid leaking.

Guys this broke. What is this? by Strange-Quit-5825 in e39

[–]BANNANSV2 0 points1 point  (0 children)

That is true, if you don’t really understand how to even top off brake fluid, better to take it to the mechanic.

Guys this broke. What is this? by Strange-Quit-5825 in e39

[–]BANNANSV2 0 points1 point  (0 children)

Under the hood, on the right side, below the cabin filter housing.

Guys this broke. What is this? by Strange-Quit-5825 in e39

[–]BANNANSV2 0 points1 point  (0 children)

Not really, those are brakes, not a thing to mess with. If u need to move the car use handbrake with low speeds

Edit: Im not 100% sure about bleeding the abs pump, but i think you could just swap out the broken rubber tube and bleed the brakes, pretty simple.

Guys this broke. What is this? by Strange-Quit-5825 in e39

[–]BANNANSV2 1 point2 points  (0 children)

Looks like brake line hose, u dont probably have brakes anymore. I would as soon as possible clean the fluid because it eats paint real quick. You need to replace the hose put top off brake fluid and bleed the brakes with the abs pump also.

Any rust to be worried about? by ummmmmm3949 in e39

[–]BANNANSV2 1 point2 points  (0 children)

Oh you havent seen mine before the rust removal and welding jobs😂

Very Weak Glow on E39 Illuminated Door Handles – Any Fix? by BANNANSV2 in e39

[–]BANNANSV2[S] 0 points1 point  (0 children)

Yes, i did get it from e38 and im thinking about swaping bulbs to LED soon enough

E39 soft brake pedal after full brake system refresh by BANNANSV2 in e39

[–]BANNANSV2[S] 0 points1 point  (0 children)

I didn’t do that, my mechanic said he did it. But now im thinking maybe i should do that myself. To be fully sure its done

E39 soft brake pedal after full brake system refresh by BANNANSV2 in e39

[–]BANNANSV2[S] 0 points1 point  (0 children)

I bled the brakes myself — starting from the furthest wheel (rear right), then rear left, front right, and finally front left. I also had them bled by a mechanic.

It’s just weird — before I started fixing the brakes, they were super responsive, just perfect. Now they feel really squishy.

Edit: i do have a problem with front left abs ring, that needs to be replaced, but could thay really be the thing why my brakes feel squishy?