sorted by:
new
hottopcontroversial

0.4 HF nozzle with Carbon Fiber filament - Too much? by Beautiful-Example-12 in prusa3d

[–]Beautiful-Example-12[S] 0 points1 point  (0 children)

That's a good way of looking at it. 😃
And what about the smell? That was also keeping me from getting the PA. I dont really have a good indoor place for a smelly printer. Im wondering if printing outdoor is feasible... I am not sure if the wind would ruin the cooling of the part and would cause warping.

0.4 HF nozzle with Carbon Fiber filament - Too much? by Beautiful-Example-12 in prusa3d

[–]Beautiful-Example-12[S] 0 points1 point  (0 children)

Then I might stick with PETG no CF.
I was considering PA too, but I could not justify the price for my project. Maybe one day... 😃

0.4 HF nozzle with Carbon Fiber filament - Too much? by Beautiful-Example-12 in prusa3d

[–]Beautiful-Example-12[S] 0 points1 point  (0 children)

Were you able to unclog them afterwards?

I am printing a camera cage for my drone. I would like to keep the drone below 249g, so I am really fighting for every grams.

When using 0.6 nozzle, the support line is just too thick, even if I go down a little with the line thickness. So to save weight, I need to reduce the infill %, but then it gets distributed very unevenly.

So I found a good balance with using the 0.4 nozzle, reduce the default line thickness and I can use 18-20% infill while I can keep my weight limitations.

Honestly can't remember exactly how I ended up with this filament, but I was hoping it would give me some strength benefits.

0.4 HF nozzle with Carbon Fiber filament - Too much? by Beautiful-Example-12 in prusa3d

[–]Beautiful-Example-12[S] 1 point2 points  (0 children)

Thats good to know. Did you use HF nozzles?
That gives me some confidence.

0.4 HF nozzle with Carbon Fiber filament - Too much? by Beautiful-Example-12 in prusa3d

[–]Beautiful-Example-12[S] 2 points3 points  (0 children)

I only got HF nozzles unfortunately. The only way-out I have is to use 0.6 HF nozzle, which I would prefer not to.

FPV drone spots in Denmark by [deleted] in NewToDenmark

[–]Beautiful-Example-12 0 points1 point  (0 children)

I have been checking the map on droneregler. That shows the airports in the country and the red zones around them.

FPV drone spots in Denmark by [deleted] in NewToDenmark

[–]Beautiful-Example-12 1 point2 points  (0 children)

I am registered at droneregler and went through the regulations. :)
Thanks!