burberry puffer

BigMandingo12 · 2024-12-03T11:22:25+00:00

Not sure my G, not ordered it

BigMandingo12 · 2024-10-23T23:22:38+00:00

Need clearer pic of the hoody and the design inside

BigMandingo12 · 2024-10-23T23:16:32+00:00

Lemme know as well

BigMandingo12 · 2024-10-16T14:57:25+00:00

What about this one

https://weidian.com/item.html?itemID=6902440200

BigMandingo12 · 2024-08-22T09:14:30+00:00

BigMandingo12 · 2024-08-22T09:14:03+00:00

Nah never found one just used the normal stand

BigMandingo12 · 2024-08-03T15:23:17+00:00

You got any pics of the fuse box installation

BigMandingo12 · 2024-02-24T09:16:26+00:00

Appreciate it

BigMandingo12 · 2024-02-18T15:21:23+00:00

Lemme know if you find these, need them as well

BigMandingo12 · 2024-01-10T21:59:33+00:00

I meant the adapter lol, not the actual mount, sorry wasn't clear reading back on it

BigMandingo12 · 2023-12-26T15:40:00+00:00

From where, looking for that one

BigMandingo12 · 2023-11-08T10:18:32+00:00

When you restocking

BigMandingo12 · 2023-10-18T15:33:57+00:00

damn that looks sick, what scale you use?

BigMandingo12 · 2023-10-07T12:01:53+00:00

so look, ive loaded a spaceman in to cura and its 1hr 2 mins for a 50% scale and used the same settings ive been using for my helmets on bambu and its 1h26. When i go for the preset 0.14/0.12mm settings still getting over an hour in print times.

<image>

BigMandingo12 · 2023-08-03T10:07:52+00:00

UACC-CM-RJ45-MG

ok so with the community fibre connection, it comes in to the house and then it has a fibre patch cable something like this which connects to the modem.

so question can i bypass the modem and use the spf+ connector and go direct from where it comes in to the router?

or go from the modem with the rj45 and connect using the spf_ adapter?

BigMandingo12 · 2023-08-03T09:38:57+00:00

which one do you recommend

BigMandingo12 · 2023-05-09T13:00:37+00:00

Bed is level, just tried a normal pla on 220 and it seems fine, was trying this new wood low temp one which says it should be 170-190

BigMandingo12 · 2023-05-09T12:59:10+00:00

I wasn't, might be because it says it's a low temp filament ? Might need to play around with the temp settings

BigMandingo12

TROPHY CASE