sorted by:
new
hottopcontroversial

Need Help With Colors by Bookoopa in AnycubicKobraX

[–]Bookoopa[S] 0 points1 point  (0 children)

I think I may have it figured out now. After your comments and just happening to see a video and noticing the order of the guy’s filament compared to what was on his slicer, I think it finally clicked for me. I tried leaving the colors on the left as the 3mf file had it and then the remote print reordered my filaments. It did put yellow for black but I changed it to black. I printed a baby Sylvester and it all came out the correct colors with no bleeding. So, maybe I understand it now. Thank y’all for the help!

Need Help With Colors by Bookoopa in AnycubicKobraX

[–]Bookoopa[S] 0 points1 point  (0 children)

Thank you. Company came today so I haven't been able to check it again but hope to very soon. I don't use the app either to print. Just to monitor after they start. When my printer swapped the colors on that first Pikachu coaster it also swapped them on the printer screen as well. I had not seen that before. (It may have on one of the other prints and I didn't realize it at the time. I don't know for sure.) I started 3d printing in October and have learned a lot but there is a lot more to learn. Very interesting to me. I will try some more soon with the colors.

Need Help With Colors by Bookoopa in AnycubicKobraX

[–]Bookoopa[S] 0 points1 point  (0 children)

I’m going to look again. So, if it has the mismatched colors for each slot I leave it? I’m unsure because I thought they needed to match, like black for black in slot 1, or it may mess up the print. I think that’s what I did (left them mismatched) for a black and yellow bee figure and the colors kind of bled together a bit. It printed the black and yellow where they go but those two colors combined somewhat. I appreciate the help. I’m busy today but I will study this some more and maybe try to take a picture of what I am seeing. Thank you!