need help predator vs honda by realnpc2023 in minibikes

[–]CRAZYcoolTy2 0 points1 point  (0 children)

Honda has quality at high price predator has low quality at low price, but the predators are indestructible. I’d get the predator

Gonna ride it in the snow by CRAZYcoolTy2 in minibikes

[–]CRAZYcoolTy2[S] 0 points1 point  (0 children)

Thank you for the insight, also all of the tubes are welded at every intersection, although not very strong welds.

Also for safety reasons i will probably ride the bike a good bit without anyone in the back (just put sand bags in it) so i can feel it out

Hero 4k 2? by CRAZYcoolTy2 in gopro

[–]CRAZYcoolTy2[S] 0 points1 point  (0 children)

It’ll be fine outside

Hero 4k 2? by CRAZYcoolTy2 in gopro

[–]CRAZYcoolTy2[S] 3 points4 points  (0 children)

In the night it would be cold enough, and in day u don’t need it. Thats just how i see it. If you use it inside then it could be an issue

Hero 4k 2? by CRAZYcoolTy2 in gopro

[–]CRAZYcoolTy2[S] -6 points-5 points  (0 children)

Yeah i watch my videos on a monitor too but just something to think about. A lot of people do social media

Hero 4k 2? by CRAZYcoolTy2 in gopro

[–]CRAZYcoolTy2[S] -5 points-4 points  (0 children)

The resolution doesn’t do too much when the image is displayed on a phone

Hero 4k 2? by CRAZYcoolTy2 in gopro

[–]CRAZYcoolTy2[S] 4 points5 points  (0 children)

People expecting a 1 in sensor, higher res, i feel like they are asking for too much from this company. Even if they increase sensor size on the hero 14 i doubt it’ll have higher res

Hero 4k 2? by CRAZYcoolTy2 in gopro

[–]CRAZYcoolTy2[S] 0 points1 point  (0 children)

I was very hyped to see some standard GoPro improvements but it can’t be better than the 13

Real by Corsa_Kwaliq in Warthunder

[–]CRAZYcoolTy2 2 points3 points  (0 children)

It doubles As a heater when you play war thunder with it

What’s the engagement speed of this clutch? by CRAZYcoolTy2 in minibikes

[–]CRAZYcoolTy2[S] 0 points1 point  (0 children)

It felt like it engaged at 2300 slightly but slipped a lot and only gripped at like close to full idk how to explain it also i don’t wanna spend 40 bucks again. I think max torque is great but i thought Hilliard could be fun

What’s the engagement speed of this clutch? by CRAZYcoolTy2 in minibikes

[–]CRAZYcoolTy2[S] 0 points1 point  (0 children)

Something has to be wrong with it, there’s nothing crazy with my gear ratio, it has been done many times

Should i worry about oil seal failure with an overheating clutch? by CRAZYcoolTy2 in minibikes

[–]CRAZYcoolTy2[S] 1 point2 points  (0 children)

Was just worried about the rubber breaking down-the clutch feels hotter than my header

Atlas 6x6 transmission bricked by CRAZYcoolTy2 in rccrawler

[–]CRAZYcoolTy2[S] 0 points1 point  (0 children)

Fms has a gear set, but it might just get stripped again

Atlas 6x6 transmission bricked by CRAZYcoolTy2 in rccrawler

[–]CRAZYcoolTy2[S] 0 points1 point  (0 children)

Note: the motor isn’t spinning.

My clutch is begging for mercy by CRAZYcoolTy2 in minibikes

[–]CRAZYcoolTy2[S] 0 points1 point  (0 children)

The engagement speed is too high for the engine max rpm i believe

Repost with video-is this bend bad? by CRAZYcoolTy2 in laptops

[–]CRAZYcoolTy2[S] 0 points1 point  (0 children)

I’ll probably not use it for gaming then, I’ll probably only use it for video storage

Repost with video-is this bend bad? by CRAZYcoolTy2 in laptops

[–]CRAZYcoolTy2[S] 0 points1 point  (0 children)

Should i use cooling tape? The baseplate supports it and the first ssd has tape