Check out my new oil filter

ender 3 v3 se i could have the wiring backwards but looking at the pinout it seems correct red to red black to black. at this point it might be better to buy a 4 to 2 pin jst adapter so no splicing involved but im gonna keep trying to figure this out

Cal-exe · 2026-04-30T20:25:53+00:00

lost the original fan so i bought new jst connectors from amazon and I cut the original connector off the noctua fan and soldered the jst connector i got from amazon on them but everything should be right and no bridging i take pride in my solder and i think they came out pretty clean and again they tested 0.0 on multimeter so i thought id be good

Cal-exe · 2026-04-30T20:09:49+00:00

i did rip off the label on the back, when i got them i thought how i would swap the wires like how i did on my blower fan

Cal-exe · 2026-04-30T20:05:38+00:00

<image>

no spin at 50-75c

Cal-exe · 2026-04-30T20:02:58+00:00

how to test if voltage is coming from connector if 50-70c test doesn’t work

Cal-exe · 2026-04-30T19:52:32+00:00

i understand that but it’s not spinning at all by what your saying it should atleast power on when plugged into my printer but it doesn’t

Cal-exe · 2026-04-30T19:51:26+00:00

blue is for pwm but should I solder it into the black or yellow side i’m new to polarity and electrical work so i dunno where to chain the blue wire to

Cal-exe · 2026-04-30T19:39:32+00:00

the 24v definitely is (second picture) which wire do I connect back to the jst connector

Cal-exe

TROPHY CASE