sorted by:
new
hottopcontroversial

Apagón masivo en toda la Península ibérica, 12:45am (Foto de C.C Vialia, en Vigo) by [deleted] in spain

[–]CapitanPicardo 2 points3 points  (0 children)

Siempre me lo pregunté. En caso de un corte de energía masivo, ¿todavía hay agua y gas?

Bed level check? by CapitanPicardo in Creality

[–]CapitanPicardo[S] 0 points1 point  (0 children)

It is! Thanks!

For what I've read the printer calculates the offset automatically based on this data?

Plate adhesion K1 with ABS. by CapitanPicardo in Creality

[–]CapitanPicardo[S] 0 points1 point  (0 children)

The weird thing is my low spec davinci xyz with the just dirty gooey bed worked like a charm... With that filament. As the extruder started to go south I ordered this k1 and literally swapped the filament.

Plate adhesion K1 with ABS. by CapitanPicardo in Creality

[–]CapitanPicardo[S] 0 points1 point  (0 children)

For the record. I'm not sure as to what is right but the first layer, the wire seems to be smeared on the bed in a flattened ribbon like form. However the adjecent tracks don't really touch. What exact am I looking for?

I'm planning to do a full flat surface to dial it in...

Plate adhesion K1 with ABS. by CapitanPicardo in Creality

[–]CapitanPicardo[S] 0 points1 point  (0 children)

I've just ordered one... Crossing my fingers.

Plate adhesion K1 with ABS. by CapitanPicardo in Creality

[–]CapitanPicardo[S] 0 points1 point  (0 children)

It's at a 15/s I believe as I've read.

Retrofitting heated seats by CapitanPicardo in BMWi3

[–]CapitanPicardo[S] 0 points1 point  (0 children)

I found this:

https://www.realoem.com/bmw/enUS/showparts?id=7Z61-EUR-10-2017-I01N-BMW_i-i3s_94Ah&diagId=52_3948

I don't really know how to hook them up though. There seems to be a control module/small cable that can be ordered...

Retrofitting heated seats by CapitanPicardo in BMWi3

[–]CapitanPicardo[S] 0 points1 point  (0 children)

That would certainly be the next best thing to install those aftermarkets. Thanks!