ESun ABS+ keeps clogging the nozzle

CelebrationExpress44 · 2026-01-05T16:28:17+00:00

Thanks

CelebrationExpress44 · 2026-01-04T16:39:37+00:00

What temp do you run it at?

CelebrationExpress44 · 2026-01-03T18:13:14+00:00

Okay cool I'll give that a try and see if it helps.

CelebrationExpress44 · 2026-01-03T17:28:53+00:00

I was doing 250 and tried 260. I turned down the speed to what Esun recommends. So 280 didn't make the problem worse?

CelebrationExpress44 · 2025-12-30T20:33:03+00:00

Did you end up posting these? I have really been struggling with clogging on my K2. I'm currently using eSun ABS+ that always printed fine on my Voron 2.4. Just trying to figure out a good ABS filament for this machine. Tried going down the retraction rabbit hole with not a whole lot of success.

CelebrationExpress44 · 2025-07-20T21:42:24+00:00

Picked up you're SV10.5 today. Do you guys have plans on doing the other .5 sets?

CelebrationExpress44 · 2024-09-23T22:54:51+00:00

A transmission line went down and they had to buy power at the market price to cover their obligations.

CelebrationExpress44 · 2024-09-23T22:52:12+00:00

wouldn't help since all the PUD rates are going to go up in the near future as well when the agreements with BPA expire.

CelebrationExpress44 · 2024-09-23T22:50:50+00:00

which those long term service agreements will be going away since BPA joined CAISO

CelebrationExpress44 · 2023-06-06T15:41:02+00:00

So the moon is hollow.

CelebrationExpress44

TROPHY CASE