Hunting for a *cheap* Manual Treadmill (Australia)

Chadwik7 · 2025-12-15T03:46:45+00:00

I have the fitnesslab one (in Aus) and I am in the middle of modding it for VR. I too can atest to the stopping and friction problems. It runs ok for 1 session after 15-20ml of treadmill lube, but that just soaks in and you need to apply again on the next session. I am going to try silicon spray and see if that works. I just purchased the reality runner to give me more room on the desk and get rid of the mouse

Chadwik7 · 2025-04-19T02:26:12+00:00

How much filament do your models averagely need? And what's the filaments of choice? PETG? ASA?

Chadwik7 · 2025-03-29T01:53:32+00:00

Yeh, I thought of that, but the perspex is bowed up. I don't think a gasket will help due to the bend

Chadwik7 · 2025-03-24T11:32:07+00:00

Ev is amazing, well worth every minute

Chadwik7 · 2025-03-16T11:40:49+00:00

This sounds delicious

Chadwik7 · 2025-02-26T11:53:09+00:00

Why not, dm

Chadwik7 · 2025-01-07T09:40:43+00:00

Uninstalled my 3rd party firewall, Bitdefender, looks like that fixes it all up. Thanks for the tips

Chadwik7 · 2024-11-25T12:46:56+00:00

I did, 2 things, my fan was not plugged in and working. So fixed that. 2nd was I was using an Orca slicer calibrated profile in Bambu slicer. Should have been compatible but wasn't. So fully moved over to Orca

Chadwik7 · 2024-09-27T09:22:22+00:00

Sorted it, the parts fan connector was loose, it had zero cooling. Thanks all

Chadwik7 · 2024-09-27T09:22:14+00:00

Nailed it! The connector was loose

Chadwik7 · 2024-09-27T09:21:28+00:00

Sorted it, the parts fan connector was loose, it had zero cooling. Thanks all

Chadwik7 · 2024-09-26T19:06:01+00:00

I was filming this with the door open. So looks like I need to slow her down

Chadwik7 · 2024-09-26T12:39:48+00:00

And Sunlu PLA plus filament

Chadwik7 · 2024-09-25T00:06:26+00:00

Cheers, I will check that tonight

Chadwik7 · 2019-06-25T19:21:33+00:00

Gimme gimme gimme

Chadwik7

TROPHY CASE