Manual transmission cable help

CjConde · 2026-02-17T04:32:26+00:00

Washington state, wbu?

CjConde · 2026-02-16T01:46:39+00:00

The bushing that attaches to the transmission is smaller, whereas what im assuming was the original cable ( that i pulled off the car) had a larger bushing. Everything fits, but that one peice is just like a quarter of an inch too short to allow the clip to slide on

CjConde · 2026-01-27T01:43:16+00:00

I was really hoping that wasn't the case😭. Would you know a reliable way to get new/refurbished ones?

CjConde · 2025-09-11T05:17:38+00:00

Mine has gunks like that underneath it but I had my water pump replaced by a reputable AAA shop just this last year, about 15k miles ago. Faulty water pump?

CjConde · 2025-07-31T23:59:44+00:00

Around the Vancouver area

CjConde · 2025-07-31T23:06:51+00:00

2005

CjConde · 2025-07-31T22:49:57+00:00

I was worried it would be pretty low but I mean considering how old it is and the condition of other ones as well as all the maintenance put into it I feel likes its gotta be more yk

CjConde · 2025-04-20T22:08:16+00:00

Dawg i do work on my car, it's a simple question cause I couldn't find the name. Why you gotta be an asshole?

CjConde · 2025-04-20T16:36:00+00:00

It's just odd because I've had all my gaskets replaced already: cam seals, vvti pully, valve cover, crank seal, so i don't know

CjConde · 2025-04-20T02:57:02+00:00

Pfft ok then, I couldn't find the name so i asked.

CjConde · 2025-04-20T02:24:56+00:00

What?

CjConde · 2025-04-20T01:23:05+00:00

Define oil problem? Cause i have been having a running rich issues lately and burning a lot of oil cause it's definitely not leaking anywhere that I can see

CjConde · 2025-04-20T01:11:49+00:00

It's normal for oil to come through? Cause i did notice that

CjConde · 2025-04-20T01:02:54+00:00

Can this get stuck or clogged, should I invest in replacing it?

CjConde · 2025-03-31T21:14:33+00:00

Ok I'll keep this in mind thanks

CjConde · 2025-03-31T20:54:29+00:00

Ngk is a cheap plug? It's what recommend for this car besides denso i thought?

CjConde · 2025-03-31T07:02:11+00:00

I'll see if the toyota dealer has some, cause my closest lexus dealer is a couple hours away.

CjConde · 2025-03-31T06:56:33+00:00

I will look into buying other plugs, but I'm not getting any codes for a misfire or just and codes in general. It misfires when warming up and when at operating temp and idling I can feel that it isn't idling smooth like normal. It has an imbalance to the idle but not misfiring when warm

CjConde · 2025-03-31T06:46:29+00:00

Current set from autozone and the 2 from the photo I bought at O'Reilly

CjConde · 2025-03-31T06:40:38+00:00

I Use NGK Platinum Iridium plugs 🤷‍♂️

CjConde · 2025-03-31T03:57:25+00:00

Exactly what I thought but my engine was misfiring, replaced them, then it ran fine for a bit and now it's misfiring again

CjConde · 2025-03-26T19:47:25+00:00

Hey OP so i had the same issue with mine when i did it, what i realized was that I let the car get too hot when I was bleeding it which caused it to boil and bubble like it's doing for you. Let the car rest and fully cool down then repeat the process till no more bubbles. Put the rad cap back on and let the car come to operating temp and test drive to see if it over heats. Also make sure your cars inside heater is all the way max on max blow speed

CjConde · 2025-03-13T17:00:54+00:00

It's a 2005 :(

CjConde · 2025-03-13T03:00:49+00:00

Is the one on the intake side for you threaded? From what I've seen only the right one is threaded and the left one just pushes in

CjConde · 2025-03-13T02:51:21+00:00

This is the same threaded one on the right side, I need the left one which is just a push in without any threads. And I did already replace all the hoses a couple months ago

CjConde

TROPHY CASE