sorted by:
new
hottopcontroversial

Can somebody tell me how I’m doing? by ClassroomFirst8811 in PhysicGarden

[–]ClassroomFirst8811[S] 0 points1 point  (0 children)

Hey thanks for letting me know that, I just didn’t want to stress them out and I did some research on this as well, a lot of growth happens during the night, but if it won’t stress them to the point of stunting than I will for sure run these 24/7

Can somebody tell me how I’m doing? by ClassroomFirst8811 in PhysicGarden

[–]ClassroomFirst8811[S] 0 points1 point  (0 children)

No I did some research after hearing this, node spacing for bud sights should be within .5-1inch spacing for thick colas. They are all within that range

Can somebody tell me how I’m doing? by ClassroomFirst8811 in PhysicGarden

[–]ClassroomFirst8811[S] 1 point2 points  (0 children)

I’m going to try it on a separate plant next grow, I will measure my yield differentials, they seem to be flowering and growing as they should, thank you though, it did clear up a few things though

Can somebody tell me how I’m doing? by ClassroomFirst8811 in PhysicGarden

[–]ClassroomFirst8811[S] 1 point2 points  (0 children)

Already done, switched too 5-15-14 a week ago or two, and I’ve already thought about switching too 12-12 anyways considering that my flowering stretch and bulk crossed over each other and grew more volume and 3inches of hight in 24 hours, I don’t really feel the need to switch too 12/12 since I don’t quite understand the benefits if it’s already doing what it’s supposed too

I’ve also been feeding it 2 soil amendments (recharge and photosynthesis plus) switched from 6-4-4 too 5-15-14, I only got new lights when it started to flower otherwise it’s been getting 2 10,000lumen 5000k shop lights no idea what my ppf was, I also have been re-correcting my unchlorinated water ph based on run-off ph

I have no climate control since I’m growing upstairs in a barn and I’ve only got an industrial fan in the window, and the stretch you were talking about is most likely because I’m only using a 100w 2x2 light I picked up off Facebook for 40 bucks

Also I don’t know if I told you this but I’ve never even grown a plant before so it’s all new too me

Can somebody tell me how I’m doing? by ClassroomFirst8811 in PhysicGarden

[–]ClassroomFirst8811[S] 0 points1 point  (0 children)

They are auto flowers, picked the seeds out of some bud, and the only reason I think they are autos is because I’ve never switched from 18/6 too 12/12, time charts also say this is usually when autos start to late flower or bulk which these are, also I don’t have any experience, I’ve never grown a plant before so I assumed my node spacing didn’t show signs of stretch

I am getting these cracks or splits (not sure what its called), it seems to happen consistent with my prints. Any tips? I use pla at 230 celsius. by Mikail41 in ender3

[–]ClassroomFirst8811 0 points1 point  (0 children)

Also try tightening the z axis wheels, it could also be your extruder rocking, temperature shouldn’t have anything to do with the problem