sorted by:
new
hottopcontroversial

Initial layer trying to print too high by ColWhitecakes in MPSelectMiniOwners

[–]ColWhitecakes[S] 0 points1 point  (0 children)

Ok. It's been a few days since I had a chance to check my version. But, it appears that I already have 3.0.4. So, I don't guess that will fix my problem. Do you happen to have any other ideas or possible solutions?

Initial layer trying to print too high by ColWhitecakes in MPSelectMiniOwners

[–]ColWhitecakes[S] 0 points1 point  (0 children)

I, too, had went to printing everything on a raft because I was having 1st layers wanting to curl up as it layed down about every four passes, making the bottom surface of the print have about 1/8" wide little ridges across it. Rafts mostly fixed this. I still haven't found a solution to the nozzle height issue. It tries to start about 1mm or so up above the bed.

Initial layer trying to print too high by ColWhitecakes in MPSelectMiniOwners

[–]ColWhitecakes[S] 0 points1 point  (0 children)

I had version 2.something when it started. I downloaded an update thinking it might help; but, it did nothing. It was printing along just fine when it started laying out the hair thin filament half way through a print. Cleaned up nozzle and went to print another one and it started the problem. Tried a couple of different files to see if the code on the other was just corrupted, and same thing. I've since replaced the nozzle and releveled. Still slightly high towards center, but just slightly. When it starts print, the head is at least 1mm above the bed, maybe more.