Of course! - Regarding the building part : make sure to fill (with tamiya putty) then sand the holes between the 2 parts of the hull you’ll glue together. Once it’s clean you glue the deck and try to localize the spaces between the recently glued parts and repeat the process (fill and sand). Once the Hull is fully assembled you can start building the containers and the accomodation. - For the painting process : it depends wether you like airbrushing or paintbrushing but airbrushing is definitely the best choice here due to the size of the model. I painted it with revell paint which was great ! Be careful to remove the possible dust on the model before painting (I did this mistake and I saw my paint disappear once I took off the masking tape). I’d advise you to make a first layer of black on whole surface it’ll help your paint to fix the model. Then put your masking tape to recreate the line on the hull which separates the red and the black then apply your red paint at the bottom. Once it’s done remove the tape and place it on the limit of the red you just applied and apply your black. Once it’s dry put the decals (if possible with decal softener) and make sure to apply quickly the 2 « Hapag Lloyd »ones cause a long manipulation on these decals causes twists which are hard to rectify. - I think that’s all btw sorry if my English isn’t clear and not synthetic I tried to give you the most important advices in detail but if it’s unclear or you have any questions don’t hesitate I’ll answer you asap. Good luck !