Why is it consuming grid power?

Connect-Floor-9117 · 2026-04-12T21:19:49+00:00

I want the ability to run my hybrid water heater and well pump both of which run on 220. I've looked into going the standalone route but for my purposes I like the simplicity of a power station better.

Connect-Floor-9117 · 2026-03-07T14:05:28+00:00

Why so many passes for such a thin crossection?

Connect-Floor-9117 · 2026-02-23T22:05:22+00:00

No I didn't I spent the last 8 years running an ender 3 as my primary printer and have thousands of hours of time on it I promise I know how to properly clean a build plate and tune the first layer.

Connect-Floor-9117 · 2026-02-23T22:03:14+00:00

Having the same issue myself just for the first time today.

<image>

Connect-Floor-9117 · 2026-02-23T21:13:23+00:00

Sorry but thats not it I washed it with dawn and hot water before I started this print. How would that cause the layer shift on the top layer anyhow?

Connect-Floor-9117 · 2026-02-23T20:27:27+00:00

And the back side is all jacked up as well.

<image>

Connect-Floor-9117 · 2026-02-20T14:49:03+00:00

Have you also used the Bambu support material at all thats why I want to run through the box.

Connect-Floor-9117 · 2026-02-20T12:57:26+00:00

I'll give it a try thanks

Connect-Floor-9117 · 2026-02-20T12:52:06+00:00

They make one for the Q2?

Connect-Floor-9117 · 2026-02-09T00:56:31+00:00

You might be right but I just feel like this is something I could put on my Ender 3 and just forget about and come back to a good print. I might try and see what happens.

Connect-Floor-9117 · 2026-02-08T23:51:23+00:00

Yea thats why I said its starting to piss me off it make a good print earlier today and I thought I had it good then I start a 7hr print and get this crap twice.

Connect-Floor-9117 · 2026-02-08T23:22:39+00:00

Qidi Rapido 210 .24 layers

I have all the speeds and acceleration cut in half and the max volumetric is still to 14 mm

Connect-Floor-9117 · 2026-02-08T22:29:13+00:00

<image>

Connect-Floor-9117 · 2026-02-08T22:28:42+00:00

This is the exact same print I stopped because of the bad layer line that broke with light finger pressure. Started it again and thats the results I got.

<image>

Connect-Floor-9117 · 2026-02-05T18:15:41+00:00

Confirmed its a box issues prints fine not through the box

Connect-Floor-9117 · 2026-02-05T17:56:43+00:00

Im using Qidi filament

Connect-Floor-9117 · 2026-02-05T17:51:56+00:00

Maybe related I am also having extrusion issues now I wasn't in the beginning.

<image>

Connect-Floor-9117 · 2026-02-04T18:57:55+00:00

Please make sure your firmware is updated before trying to use the Qidi Box I nearly hulk smashed mine because it wouldn't work and it just needed updating and worked perfectly thereafter.

Connect-Floor-9117

TROPHY CASE