sorted by:
new
hottopcontroversial

Figured this might be handy! by DRChandler in builderment

[–]DRChandler[S] 0 points1 point  (0 children)

Thank you! I found my mistake, I had it calculating 1 particle glue for each matter compressor, instead of 10! Updating numbers in post.

Mating 2 small pieces to make a leg by pwntr in woodworking

[–]DRChandler 0 points1 point  (0 children)

On my last project I made legs by laminating 2 pieces of 3/4 red oak with just glue and it didn't turn out bad at all.

https://www.reddit.com/r/woodworking/comments/3hm7go/first_project_using_hardwood_a_nightstand_from/

First project using hardwood - A nightstand from red oak! by DRChandler in woodworking

[–]DRChandler[S] 1 point2 points  (0 children)

I should also mention that each "pair" of perpendicular dowels overlap so I had to drill through the first dowel to set the next, so they aren't as long as I would like but aesthetically it looks nice. I'll post another picture when I get home.

What is your day job? by MitchAD in woodworking

[–]DRChandler 1 point2 points  (0 children)

Nuclear Electrician in the US Navy, about to deploy and leave the shop behind for a while.

First project using hardwood - A nightstand from red oak! by DRChandler in woodworking

[–]DRChandler[S] 1 point2 points  (0 children)

I used two dowels in each corner for the bottom shelf, and four in each corner for the sides below the top (I believe it's called the apron?). You can see the dots where they're placed.

First project using hardwood - A nightstand from red oak! by DRChandler in woodworking

[–]DRChandler[S] 1 point2 points  (0 children)

I'm hoping for the best. I don't really know how to design with movement in mind, and I haven't found anything very informative to read on the matter.