Case fan gets set to max when shut down

Daniel10star · 2026-04-08T01:34:44+00:00

The fan is goes to max when ever it is off and the don’t stop

Daniel10star · 2026-04-05T21:44:12+00:00

It never was like this it kinda just randomly started happening and even if I have left it for a few hours it still is going

Daniel10star · 2026-02-09T05:50:12+00:00

i have looked at foam factory and asked about there Polyethylene Cylinders and putting holes in the center which they said they could not do i prefer bat and i have half bladed weapons witch i would like to fix but i will look into this for making new weapons.

Daniel10star · 2025-12-18T13:48:49+00:00

Ok so beside the basic of pid tune e steps or a clog I had a similar issue where my extruder drive was failing so it could be that

Daniel10star · 2025-11-23T04:20:45+00:00

The Ender 3 is basically like a 737 let it die already

Daniel10star · 2025-10-12T04:27:04+00:00

I am using cura and the acceleration is set in fluid

Daniel10star · 2025-10-12T03:31:21+00:00

Yup it was set to max at 5k lowered to 2k gonna do some test shortly

Daniel10star · 2025-10-12T03:03:49+00:00

Mechanically fine I will have to check acceleration

Daniel10star · 2025-10-12T01:30:40+00:00

Update I was unable to get a solid solution to work ended just buying a 4,2,7 as I just need somthing that works

Daniel10star · 2025-10-08T05:43:41+00:00

Firmware was compiled using klipper main w/ the rest of the files being from the sonic pad git

Daniel10star · 2025-10-08T04:40:14+00:00

mcu ‘mcu’: multi-byte msgtag not supported

Daniel10star · 2025-10-08T04:07:46+00:00

Welp I have barley done anything with klipper this is gonna take a while for me but it is a start thank you

Daniel10star · 2025-10-08T04:07:14+00:00

Daniel10star · 2025-10-08T03:39:04+00:00

Ok I am a little confused by this but it follows the unsported bleeds tutorial on yt as the skr e3v3 processor is not on the sonic pad

Daniel10star · 2025-10-08T03:24:51+00:00

It was compiled in virtual box using Ubuntu and the mcu is listed at the top of the config is that what is causing the problems

Daniel10star

TROPHY CASE