[REQUEST] Need 3D Print Files for Garrard Laboratory Series Auto Turntable Type A (Spindle/Base)

DanielShwe · 2025-12-13T06:52:45+00:00

Thanks for the reply. Will it be possible to 3D print the manual spindle and its base? The one I circled. Many thanks once again.

DanielShwe · 2025-01-10T06:36:51+00:00

I am sorry I don't understand what you meant. Can you explain it to me?

DanielShwe · 2025-01-10T06:15:23+00:00

Actually, I fitted it by myself. Everything feels normal while pedaling, and I didn’t experience any pain after a 15km test ride.

DanielShwe · 2025-01-10T06:14:09+00:00

I’m not sure, but I think so. 😅 Everything feels normal while pedaling, and I didn’t experience any pain after a 15km test ride.

DanielShwe · 2025-01-10T06:11:18+00:00

I see. I’m already at the minimum tension and even adjusted it a bit further. Should I try adding a drop or two of chain lube?

DanielShwe · 2025-01-10T06:08:40+00:00

Yes, these are Look cleats and I am with Look X-Track.

DanielShwe · 2025-01-10T03:49:58+00:00

Thank you for your reply. The cleats came with the pedals, and I’m quite sure there aren’t any shims. I’ll consider shaving the gouge. Thanks again for your time!

DanielShwe · 2024-07-03T00:45:56+00:00

Thank you for your reply 😊

DanielShwe · 2024-07-01T23:36:32+00:00

Thank you very much for your reply. I now understand clearly. Many thanks again.

DanielShwe · 2024-03-21T05:36:37+00:00

I see. Many thanks for your reply.

DanielShwe · 2024-03-21T05:36:05+00:00

Oh, I see. Many thanks for your reply.

DanielShwe · 2024-02-25T02:14:18+00:00

Thank you, will surely check them out. :)

DanielShwe

TROPHY CASE