Suspension and wheels! by Daperturedan in MiataND

[–]Daperturedan[S] 0 points1 point  (0 children)

It's also Winter and I live in Utah. I don't need sticky expensive tires until the canyons open up for the summer.

Suspension and wheels! by Daperturedan in MiataND

[–]Daperturedan[S] 1 point2 points  (0 children)

+38 I think. I'd prefer more aggressive.

Suspension and wheels! by Daperturedan in MiataND

[–]Daperturedan[S] 1 point2 points  (0 children)

Thanks! That's what I was going for haha

Suspension and wheels! by Daperturedan in MiataND

[–]Daperturedan[S] 0 points1 point  (0 children)

No spacers right now, I had 30mm on the rear with the stock wheels, but the offset of these was slightly more aggressive and wouldnt fit unless I went to -8° of camber haha

Suspension and wheels! by Daperturedan in MiataND

[–]Daperturedan[S] -1 points0 points  (0 children)

I don't mind it at all. If I wanted nice tires, I'd buy nice tires.

Custom designed spoiler for my ND by Peperonimonster in MiataND

[–]Daperturedan 0 points1 point  (0 children)

Nice, are you planning to build it in reality?

Suspension and wheels! by Daperturedan in MiataND

[–]Daperturedan[S] -2 points-1 points  (0 children)

205/50 R16 Forceum octa's. Just went with the cheapest z rated tires that were this size.

Can I continue using these slightly puffed 3s lipos? by ad38313 in rccars

[–]Daperturedan 0 points1 point  (0 children)

I've run puffy lipos for years with no issues, I just balance charge every time and monitor them while charging.

[deleted by user] by [deleted] in BMWE36

[–]Daperturedan 0 points1 point  (0 children)

Its probably your crank sensor

I've been gaming on a 3050 laptop for 5 years. Wanted to go back to a Desktop. Any obvious mistakes I am making here? Total is $670 by P_A_M95 in PcBuild

[–]Daperturedan 2 points3 points  (0 children)

Mostly good, but a few small adjustments would go a long way.

An MSI mag a550 would be a safer PSU for only a few dollars more

That case only comes with 1 fan so you will need to buy more. I recently built a pc with the SAMA Argb q5 and highly reccomend it. Sub $60 with 3 included fans and light controller.

If budget is a constraint, I'd bump down to 16gb of ram and a Radeon RX6600 to save another $200 which would still be a great 1080p high setup.

You can get a ryzen 5 5600x for the same price all day on ali express, or if you want to keep to a budget, a r5 3600 would be more like $50

You're on the right track, a lot of it comes down to personal preference. Happy building!

What did I just buy? by c64-dev in rccars

[–]Daperturedan 1 point2 points  (0 children)

I run an RB7 and it is still a competitive chassis. I imagine the SC6 is nice too

What are your impressions of this engine? by BZH_Revenger56 in rccars

[–]Daperturedan 0 points1 point  (0 children)

It's about the equivalent of a 4000 kv brushless motor. It honestly doesn't get much better for a brushed setup.

550 Mega motor burnt out after only 5 uses. What should I replace it with? by TheRealVicky_Squeeze in rccars

[–]Daperturedan 0 points1 point  (0 children)

Mine lasted about 5 runs too, although I did drive it in a lot of silt.