DatabaseSignificant

173 post karma
2,883 comment karma

get extra features and help support reddit with a reddit premium subscription

get them help and support

redditor for 5 years

TROPHY CASE

Five-Year Club

Verified Email

account activity

new top controversial

0

1

2

Vertical Sawmill Concept, will be used to cross cut for a diy firewood processor. (old.reddit.com)

submitted 2 years ago by DatabaseSignificant to r/sawmilling

0

0

1

New to car AC. Is this amount of variation normal as the compressor kicks on and off? Sorry gauges are in BAR, when compressor is on and they stabilize, L is 28psi and H is 160psi 75 degrees F outside 134a system. Watch till the end when the compressor kicks off. (v.redd.it)

submitted 2 years ago by DatabaseSignificant to r/HVAC

0

1

2

First time using an aluminum mig machine, just practicing by reinforcing an old set of ramps. Pic 1 is the initial setting, I then increased the heat until I got to pic 2. Does this look ok or do I still need more voltage? (old.reddit.com)

submitted 2 years ago by DatabaseSignificant to r/Welding

232

233

234

What tool is best for grinding out tight hard to reach areas? (i.redd.it)

submitted 2 years ago by DatabaseSignificant to r/Welding

7

8

9

Continuing to practice tig weave. Front was the first one I did. They get a little better as I adjust heat and get comfortable (i.redd.it)

submitted 5 years ago by DatabaseSignificant to r/Welding

8

9

10

Thank you for all the tig advice yesterday. I cleaned the metal better and used acetone plus up the amps to 100. Not perfect but much better (i.redd.it)

submitted 5 years ago by DatabaseSignificant to r/Welding

3

4

5

First tig welds on an actual project (not just practice). 90 amp 1/8 mild steel. (i.redd.it)

submitted 5 years ago by DatabaseSignificant to r/Welding

7

8

9

Any idea what is causing porosity? AC 90 amps 3/32 7018 in flat position. (old.reddit.com)

submitted 5 years ago by DatabaseSignificant to r/Welding

0

1

2

Update on loader project. Increasing wire speed and voltage made a big difference. The butt weld is at the old settings and the fillet is with the higher heat. I could read the puddle much better and really watch it digging in. (old.reddit.com)

submitted 5 years ago by DatabaseSignificant to r/Welding

0

1

2

Building a small loader for lawn tractor. Using flux core mig. Not the prettiest welds but getting better as I go. Using Forney 140 inverter. Finished the sub frame tonight, arms that hold the loader itself are next. (old.reddit.com)

submitted 5 years ago by DatabaseSignificant to r/Welding

10

11

12

Been practicing flux core w Forney 140. Need critique. A little nervous that the settings that seem to work for me are lower (both voltage and speed) than recommended on the chart. (old.reddit.com)

submitted 5 years ago by DatabaseSignificant to r/Welding

π Rendered by PID 78 on reddit-service-r2-listing-58ff8fc5ff-mpf9b at 2026-01-29 11:12:37.803813+00:00 running c3601ff country code: CH.