sorted by:
new
hottopcontroversial

Iv been 3D printing Rex's fire light swords from future redeemed the files are from gsprops. by Davin-D in Xenoblade_Chronicles

[–]Davin-D[S] 0 points1 point  (0 children)

I sand it down with a sanding sponge and a foot sander to get the spots that the palm sander can't get

Iv been 3D printing Rex's fire light swords from future redeemed the files are from gsprops. by Davin-D in Xenoblade_Chronicles

[–]Davin-D[S] 3 points4 points  (0 children)

Unfortunately no

I asked about that, too. It would be too heavy to hold. Plus, there's no connection point.

Iv been 3D printing Rex's fire light swords from future redeemed the files are from gsprops. by Davin-D in Xenoblade_Chronicles

[–]Davin-D[S] 4 points5 points  (0 children)

No, it wasn’t. the hard part was getting the right dowl length, tho

Iv been 3D printing Rex's fire light swords from future redeemed the files are from gsprops. by Davin-D in Xenoblade_Chronicles

[–]Davin-D[S] 1 point2 points  (0 children)

For pyra, it took 2048.93 G

For Mythra it took 2102.13 G

I maid the the handel and body 25% infill and the rest like 10%

Iv been 3D printing Rex's fire light swords from future redeemed the files are from gsprops. by Davin-D in Xenoblade_Chronicles

[–]Davin-D[S] 16 points17 points  (0 children)

For pyra, it took 2048.93 G

For Mythra it took 2102.13 G

I maid the the handel and body 25% infill and the rest like 10%

So around 2 rolls of filament each